Chery SQR 7160 sedan. Manual — part 65
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
NOTE:
The washer thickness should be adjusted as
procedures in section 1.4.1 in page 5/1. The
adjusting washer is installed between the cam
and the housing. Therefore brake rotor must be
removed, and pull shift shaft out enough as
necessary.
Install shift shaft elastic pin 06 090 with special
tool 5×46 000 119 and a hammer.
NOTE: The elastic pin opening side must face to
transmission input or output direction.
Insert pawl dowel pin 24 060 half into the house,
and place retracting spring 24 050 on dowel pin.
-70-
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
Install pawl 24 040 on dowel pin, and then install
dowel pin to stop.
Connect return spring and the pawl, and push
the spring outward.
Install the parking plunger 24 030.
As shown on figure, place return spring 06 140
on throttle valve cam 06 120..
-71-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
3.2、Installing band brake C’
Install O-ring 31 340 on groove on brake band
plunger 31 330 end. Oil O ring before installing.
-72-
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
Insert plunger into the housing, with O-ring end
facing outward for sealing.
Install adjusting blot 31 350, washer 31 360, and
adjusting nut 31 370, and screw bolt into housing
half or so.
Installing piston C’
Place washer 31 400 (thick) on piston plunger 31
390, then install elastic washer 31 404 (thin).
NOTE:
Both washers are of U shape. When installing,
concave side face each other, and move them to
the piston shoulder.
Install new O-ring 31 420 on the brake band
piston.
Install brake band piston on piston rod.
NOTE:
Piston flange must be at safety snap ring 31 450
side.
-73-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст