Chery SQR 7160 sedan. Manual — part 20
Usage, repair and maintenance specification of CAC gasoline engine
The removal and installation of oil collector assembly
removal:
——Loosen locknut of oil collector assembly and
take out the nut and flat washer
——Loosen carrier bolts and take out the bolts。
——Loosen flange face bolt of oil collector (two )
and take out the two bolts with spring washers
Fig. 76
sealing plate- filter
Z direction
Fig. 78
Fig. 77
flat washer
tightening torque
17.0-23.0Nm
screw M8
screw M6×20
oil collector
Tightening torque 8.0-12.0Nm
with spring plate screws(2)
Installation:
——Install a new sealing gasket of oil collector
on the flange face of oil pump and then install oil
collector assembly. Screw two bolts with gasket
by hand.
— — Screw the oil collector carrier into the
cylinder body with M8 bolt. At the same time,
hitch the carrier into the stud which is in the left
of the second bearing cap. Install the flat washer
and screw in the nut by hand.
——Tighten the flange face bolt of oil collector
to 8.0—12.0Nm.
——Tighten carrier bolt to 17—23Nm
——Tighten the locknut to 17—23Nm
44
Usage, repair and maintenance specification of CAC gasoline engine
4. The removal and installation of oil pump with oil seal
assembly
Fig. 82
Fig. 81
Fig. 80
Fig. 79
removal:
——Loosen six M6×30 hexagonal flange surface bolts.
Remove the bolts (as the figure indicates )
——Remove oil pump with oil seal assembly
— — Pry out the front oil seal of crankshaft by
screwdriver or chisel. Note: Don’t damage the front oil
seal bore.
——Remove seven M6 countersunk head screws (as the
arrow in figure indicates )
——Remove oil pump cover
——Take out the inner and outer rotor
45
Usage, repair and maintenance specification of CAC gasoline engine
——Check the clearance between outer rotor of oil pump
and case bore of oil pump.
Fig. 86
Fig. 85
Fig. 84
Fig. 83
The clearance between outer rotor of oil pump and
case bore of oil pump should be 0.06—0.19mm.
——Check the radial clearance between inner rotor and
outer rotor of oil pump.
The radial clearance between inner rotor and outer
rotor of oil pump should be 0.05—0.18mm.
——Check the end play of rotor
The end play of rotor should be 0.014—0.100mm.
——Remove horizontal hexagonal socket head plug (small
one)
——Take out the spring of relief valve and plunger of relief
valve.
——Check the spring load and free length
spring free length is 46mm。
spring load is 32.8N±2N when the length is 29mm.
installation length of relief valve spring is 38.5mm.
46
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст