Chery SQR 7160 sedan. Manual — part 69
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
Install a mounting carrier 5P 95 000 289. Then
turn housing by 180°.
Press bearing inner race 14 050 onto rear main
output gear 09 010 using installing socket 5×
46 000 300, and then press bearing inner race
09 040 onto rear sub output gear 09 020 with
same method.
Install main rear output gear onto the output
shaft, and then install plastic oil guide groove
09 026.
Tighten mounting bolt 14 070.
-86-
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
As shown on right figure, install washer 09 022
and sub rear output rear onto driven shaft.
Tighten bolt 09 030.
NOTE:
The whole output gear mechanism needs
adjusting by procedures in section 1.4.2 in page
5/2.
Lubricating gasket 09 210 and then install it.
Install side cover 09 220, and tighten with 11
bolts.
Tool: 27# socket spanner
Torque: 10Nm
Turn differential by 180℃ , and remove two
mounting carriers.
-87-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
Install washer 14 020, thrust bearing 14 030
and thrust washer14 040.
Install snap ring 32 020 into groove of
planetary carrier, and suddenly press both ends
of the snap ring for self-locking.
Install planetary gear mechanism into housing.
-88-
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
Install the sun gear 32 030 in the planetary
mechanism.
Install drive wheel drum 30 310 and make it
engaged with the sun gear.
Install washer 02 190, thrust bearing 02 180 and
thrust washer 02 170 onto drive wheel drum.
-89-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст