Chery SQR 7160 sedan. Manual — part 67
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
Install clutch hub 17 180 half or so, and then turn
clockwise to location.
Place clutch on special tool 5×46 000 232, and
install snap ring 17 100 with installing drift pin 5
×46 000 243.
Install 1st gear one-way overrun clutch into
housing. Turn over differential by 90℃. Ensure
one-way overrun clutch is not out of the position.
-78-
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
Install safety ring 17 190 (tooth type of thin steel
ring) and grooved nut 17 200, and tighten
grooved nut with socket spanner 5×46 000 155.
Torque:50Nm
As shown on figure, using appropriate drift, tamp
tooth ring into groove on grooved nut, enhancing
locking.
Turn over housing by 90 ℃ , check clutch
operating condition. Clockwise turn clutch,
confirm clutch can turn smoothly.
Assembling brake D assembly. Install sheet steel
17 050 first, and then install friction plate 17 060,
alternately install, and install retainer ring 17 070,
and then fix with the snap ring 17 080.
-79-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
3.4、Assembling governor driven shaft
Insert piston 33 040 into the governor case 33 030,and
fix with lock sheet 33 050.
-80-
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
Insert piston 33 070 and spring 33 070, and fix
with lock sheet 33 090.
Governor units are shown on right figure. The
piston may not be divided into three sections.
Install driven shaft into governor for adjusting
governor position much easier. Fix the governor
onto the governor hub 33 010 with four
mounting bolts 33 100.
Tool:27# inner socket spanner
Torque:10Nm
-81-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст