Jaguar X-Type Sedan and Estate (Wagon). Manual — part 427
24. NOTE: Remove the transaxle plug.
Using the special tool, install a new right-hand halfshaft seal.
25. Install a new right-hand halfshaft snap ring.
26.
CAUTION: Make sure the halfshaft constant velocity (CV) joints
do not over articulate. Failure to follow this instruction may result in
damage to the CV joints.
• NOTE: Remove the right-hand halfshaft tie strap.
Detach the right-hand halfshaft.
27. CAUTIONS:
Make sure the halfshaft CV joints do not over articulate. Failure to
follow this instruction may result in damage to the CV joints.
Make sure the halfshaft seal is not damaged. Failure to follow this
instruction may result in an transaxle fluid leak.
Attach the right-hand halfshaft to the transaxle.
Make sure the halfshaft snap ring is correctly seated.
28. NOTE: Remove the transaxle plug.
Using the special tool, install a new left-hand halfshaft seal.
29.
CAUTION: Make sure the halfshaft CV joints do not over
articulate. Failure to follow this instruction may result in damage to the CV
joints.
Attach the left-hand halfshaft.
Engage the left-hand halfshaft to the transaxle.
Tighten to 25 Nm.
30. Install the charge air cooler intake pipe retaining bolts.
Tighten to 35 Nm.
31. Install the front subframe.
For additional information, refer to:
Front Subframe - 2.0L Duratorq-
TDCi/2.2L Duratorq-TDCi (110kW /150PS) - Puma
(502-00 Uni-Body,
Subframe and Mounting System, Removal and Installation).
32. Install the battery tray.
For additional information, refer to:
Battery Tray
(414-01 Battery,
Mounting and Cables, Removal and Installation).
33. Fill the manual transaxle to the correct oil level.
For additional information, refer to:
Transaxle Draining and Filling -
Vehicles W ith: 6-Speed Manual Transaxle - MMT6
(308-03 Manual
Transmission/Transaxle, General Procedures).
Published: 11-May-2011
Manual Transmission/Transaxle - Transaxle2.0L NA V6 - AJV6/2.5L NA V6 -
AJV6/3.0L NA V6 - AJ27
Installation
Special Tool(s)
Halfshaft oil seal installer
205-115
Powertrain assembly jack
HTJ1200-2
Engine support bracket
303-021
Engine support brackets
303-1068
Installation
All vehicles
1. Install the transaxle.
Raise the powertrain assembly jack and transaxle assembly.
Align the transaxle to the clutch plate.
2. NOTE: Vehicles with 2.5L and 3.0L engines shown, vehicles with 2.0L
engine similar.
Install the transaxle retaining bolt.
Tighten to 48 Nm.
3. Install the transaxle retaining bolt.
Tighten to 48 Nm.
4. Remove the powertrain assembly jack.
Remove the transaxle to the powertrain assembly jack securing
strap.
5. Install the transaxle retaining bolts.
Tighten to 48 Nm.
6. Install the transaxle retaining nut.
Tighten to 48 Nm.
7. Lower the vehicle.
For additional information, refer to:
Lifting
(100-02 Jacking and Lifting,
Description and Operation).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст