Jaguar X-Type Sedan and Estate (Wagon). Manual — part 535
DTC
Description
Possible Causes
Action
C1977 Audio Steering W heel
Switch Circuit Short To
Ground
Radio head unit, audio
steering wheel switch circuit
- short to ground
Refer to electrical circuit diagrams, notes suspect the audio steering
wheel switch check for circuit short to ground
U0147 Lost Communication
With Gateway "B"
Radio head unit, gateway
module - no response
(D2B/MOST)
Refer to electrical circuit diagrams, notes and check radio head unit to
gateway module control and power circuit`s, install a new module as
required, refer to the new module installation note at the top of the DTC
Index
U1262 SCP (J1850)
Communication Bus
Fault
Radio head unit, ECU not
responding - internal
standard corporate protocol
(SCP) chip failure
Refer to electrical circuit diagrams, notes and check radio head unit SCP
circuit for fault, suspect the radio head unit, install a new module as
required, refer to the new module installation note at the top of the DTC
Index
U2003 Audio Compact Disk /
Disk Jockey Unit is Not
Responding
Radio head unit, CD
multichanger - no
response(D2B)
Carry out any pinpoint tests associated with this DTC using the
manufacturer approved diagnostic system. Refer to electrical circuit
diagrams, notes and check cd multichanger module and D2B circuit for
fault, install a new module as required, refer to the new module
installation note at the top of the DTC Index
U2008 Audio Phone Not
Responding
Radio head unit, telephone
control module - no
response(D2B)
Carry out any pinpoint tests associated with this DTC using the
manufacturer approved diagnostic system. Refer to electrical circuit
diagrams, notes and check telephone control module and D2B circuit for
fault, install a new module as required, refer to the new module
installation note at the top of the DTC Index
U2019 Audio Voice Module
Not Responding
Radio head unit, audio voice
module - no response(D2B)
Carry out any pinpoint tests associated with this DTC using the
manufacturer approved diagnostic system. Refer to electrical circuit
diagrams, notes and check audio voice module and D2B circuit for fault,
install a new module as required, refer to the new module/component
installation note at the top of the DTC Index
U2601 (D2B)Wake-up Line
Short To Ground
Radio head unit, gateway
module - wake-up line short
to ground
Carry out any pinpoint tests associated with this DTC using the
manufacturer approved diagnostic system. Refer to electrical circuit
diagrams, notes and check gateway module (D2B) wake-up line for short
to ground
U2602 Incomplete MOST Ring
(fault report received)
Radio head unit - (MOST)
ring circuit fault
Carry out any pinpoint tests associated with this DTC using the
manufacturer approved diagnostic system. Check radio head unit for most
ring circuit fault
U2603 Incomplete MOST Ring
(No Fault Report
Received)
Radio head unit - (MOST)
ring circuit fault
Carry out any pinpoint tests associated with this DTC using the
manufacturer approved diagnostic system. Check (MOST) ring for circuit
fault
U2604 Incomplete MOST Ring
(Corrupted Fault
Report Received)
Radio head unit - (MOST)
ring circuit fault
Refer to electrical circuit diagrams, notes and check (MOST) ring for circuit
fault
U2605 Master ECU Unable To
Initialize It's Address
Radio head unit - (MOST)
ring circuit fault (more than
one master on the MOST
ring)
Refer to electrical circuit diagrams, notes and check for configuration fault
on (MOST) ring modules. Install a new module as required, refer to the
new module installation note at the top of the DTC Index
U2606 Slave ECU Unable To
Initialize It's Address
Radio head unit - (MOST)
ring circuit fault slave ecu
configuration fault
Refer to electrical circuit diagrams, notes and check for configuration fault
on (MOST) ring modules. Install a new module as required, refer to the
new module installation note at the top of the DTC Index
U2607 Slave ECU ( switched
into bypass mode)
Radio head unit - (MOST)
ring circuit fault (slave ecu
configuration fault)
The module can be configured using the new module procedure. Check
and configure as required
U2609 (D2B)Circuit W ake-up
Line (pulse width out
of spec)
Radio head unit - wake up
line circuit fault (pulse<
50mS, pulse > 110mS)
Refer to electrical circuit diagrams, notes and check radio head unit(D2B)
wake up line circuit for fault
U2613 Navigation Module Not
Responding on D2B
Radio head unit - no
response from navigation
module
Carry out any pinpoint tests associated with this DTC using the
manufacturer approved diagnostic system. Check navigation module to
front audio control module circuit
U2614 Amp Module Not
Responding on D2B
Radio head unit - no
response from audio
amplifier module
Carry out any pinpoint tests associated with this DTC using the
manufacturer approved diagnostic system. Check audio amplifier module
to front audio control module circuit
Digital Audio Broadcast Module
CAUTION: W hen probing connectors to take measurements in the course of the pinpoint tests, use the adaptor kit, part number
3548-1358-00
• NOTE: If the control module/component is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and
Procedures manual (section B1.2), or determine if any prior approval program is in operation, prior to the installation of a new
module/component.
• NOTE: When performing voltage or resistance tests, always use a digital multimeter (DMM) accurate to three decimal places and with a
current calibration certificate. When testing resistance, always take the resistance of the DMM leads into account.
• NOTE: Check and rectify basic faults before beginning diagnostic routines that involve pinpoint tests.
• NOTE: Inspect connectors for signs of water ingress, and pins for damage and/or corrosion.
• NOTE: If DTCs are recorded and, after performing the pinpoint tests, a fault is not present, an intermittent concern may be the cause.
Always check for loose connections and corroded terminals.
DTC
Description
Possible Causes
Action
B11A411 L-Band
antenna
DAB L-Band antenna Circuit -
short to ground
Refer to electrical circuit diagrams and check DAB L-band antenna circuit for
short to ground
DTC
Description
Possible Causes
Action
B11A413 L-Band
antenna
DAB L-Band antenna Circuit -
open circuit
Refer to electrical circuit diagrams and check DAB L-band antenna circuit for
open circuit
B11-A511 Band 3
antenna
DAB band 3 antenna circuit -
short to ground
Refer to electrical circuit diagrams and check DAB band 3 antenna circuit for
short to ground
B11-A513 Band 3
antenna
DAB band 3 antenna circuit -
open circuit
Refer to electrical circuit diagrams and check DAB band 3 antenna circuit for
open circuit
U300004 Control
module
System internal failure
Install a new digital audio broadcast module
U30004A Control
module
Incorrect component installed
Install a new digital audio broadcast module or reconfigure the digital audio
broadcast module using the manufacturer approved diagnositc system
U300055 Control
module
Incorrect car configuration file
data received
Check/update car configuration file using manufacturer approved diagnostic
system
U300087 Control
module
Missing message
Check GEM for DTCs and refer to DTC index. Check information and
entertainment module for car configuration file and MOST network DTCs and
refer to relevant DTC index. Carry out MOST/CAN network tests using the
manufacturer approved equipment.
U300098 Control
module
Component or system over
temperature
Check for additional DTCs and refer to relevant DTC index, check/monitor
system for re-occurence
U300362 Battery
voltage
Mis-match in battery voltage of 2
volts or more between digital
broadcast module and GEM
Refer to electrical circuit diagrams and check power distribution to the DAB
module and GEM. Repair any wirirng faults using approved materials and
methods. Clear DTCs and tetest system to ensure correct operation.
Published: 11-May-2011
Audio Unit - Audio System
Description and Operation
Base cassette
Item
Part Number
Description
1
—
Dolby noise reduction button
2
—
Repeat CD button
3
—
Audio system display
4
-
Seek a stored number from the phones memory
5
—
Radio station pre-set buttons
6
—
Seek a stored number from the phones memory
7
—
CD track mix button
8
—
Priority programme type button
9
—
Traffic announcement button
10
—
Auto memory button
11
—
Select CD changer
12
—
Cassette play and side change button
13
—
Audio Source - AM/FM radio
14
-
Cassette eject button
15
—
CD seek forward, cassette fast forward, radio seek forward button
16
—
CD seek back, cassette fast rewind, radio seek back button
17
—
Mode button (volume/bass/treble/balance/fade)
18
—
ON/OFF push (rotary volume/bass/treble/balance/fade) knob
19
—
Phone mode - send/end button
20
—
Phone mode select button
21
—
Memory recall button
22
—
Cancel button
Base CD/MD
Item
Part Number
Description
1
-
Mutes audio
2
-
Repeat CD button
3
-
Audio system display
4
-
Seek a stored number from the phones memory
5
-
Radio station pre-set buttons
6
-
Seek a stored number from the phones memory
7
-
Mix CDs or CD/MD tracks button
8
-
Eject CD or MD
9
-
Priority programme type button
10
-
Traffic announcement button
11
-
Auto memory button
12
-
Select CD changer
13
-
Select compact disc when in other audio mode, or CD pause
14
-
Audio Source - AM/FM radio
15
-
CD seek forward, cassette fast forward, radio seek forward button
16
-
CD seek back, cassette fast rewind, radio seek back button
17
-
Mode button (volume/bass/treble/balance/fade)
18
-
ON/OFF push (rotary volume/bass/treble/balance/fade) knob
19
-
Phone mode - send/end button
20
-
Phone mode select button
21
-
Memory recall button
22
-
Cancel button
23
-
Select CD changer
24
-
Select mini disc play when in other audio mode or MD pause
Touch screen cassette
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст