Jaguar XJ (X350). Manual — part 1333

Stoplamp Switch

Removal

1 . Remove the brake pedal position (BPP) switch.

For additional information, refer to Brake Pedal Position (BPP) Switch

2 . Release the stoplamp switch.

Rotate the stoplamp switch 45 degrees clockwise.

3 . Remove the stoplamp switch.

Disconnect the electrical connector.

Installation

1

.

CAUTION: Make sure that the brake pedal remains in the rest position during this

procedure.

CAUTION: The bracket is keyed to avoid incorrect orientation. Failure to correctly

align the switch may result in damage to the vehicle.

Install the stoplamp switch.

Locate the stoplamp switch in the bracket.

Rotate the stoplamp switch 45 degrees counter-clockwise.

2 . Connect the electrical connector.

3 . Install the BPP switch.

For additional information, refer to Brake Pedal Position (BPP) Switch

www.

Rear Lamp Assembly (86.40.70)

Removal

1 . Reposition the luggage compartment floor covering.

2 . NOTE:

Left-hand shown, right-hand similar

Detach and reposition the luggage compartment side trim panel.

3 . Disconnect the rear lamp assembly electrical connector.

4 . Remove the rear lamp assembly.

Remove the rear lamp assembly retaining nuts.

Installation

1 . To install, reverse the removal procedure.

www.