Jaguar XJ (X350). Manual — part 650
Throttle Body - Vehicles With:
Supercharger, VIN Range: G00442-
>G45703 (19.70.04)
Removal
1
.
WARNING: When relieving cooling system pressure, cover the expansion tank cap
with a thick cloth to prevent the possibility of scalding. Failure to follow these instructions
may result in personal injury.
Remove the expansion tank cap to relieve the cooling system pressure.
2
.
CAUTION: Do not attempt to clean the throttle body. The bore and the throttle
plate has a special coating applied during manufacture which should not be removed.
Remove the air outlet pipe.
For additional information, refer to Air Cleaner Outlet Pipe (19.10.31)
3 . Remove the cowl vent screen.
For additional information, refer to Cowl Vent Screen (76.10.01)
4 . Remove the throttle body intake pipe.
5 . Detach the brake servo pipe.
6 . Disconnect the throttle body electrical connectors.
7 . NOTE:
Cap the coolant hoses to minimize coolant loss.
Detach the coolant hoses from the throttle body.
8 . Remove the throttle body.
Remove and discard the gasket.
www.
Installation
1
.
CAUTION: Do not attempt to clean the throttle body. The bore and the throttle
plate has a special coating applied during manufacture which should not be removed.
To install, reverse the removal procedure.
Install a new throttle body gasket.
Tighten to 10 Nm.
2 . Check and top up the cooling system.
Throttle Body - Vehicles With:
Supercharger, VIN Range: G45704-
>G99999 (19.70.04)
Removal
1
.
WARNING: When relieving cooling system pressure, cover the expansion tank cap
with a thick cloth to prevent the possibility of scalding. Failure to follow these instructions
may result in personal injury.
Remove the expansion tank cap to relieve the cooling system pressure.
2 . Remove the cowl vent screen.
For additional information, refer to Cowl Vent Screen (76.10.01)
3
.
CAUTION: Do not attempt to clean the throttle body. The bore and the throttle
plate has a special coating applied during manufacture which should not be removed.
Remove the throttle body intake pipe.
4 . Disconnect the brake servo pipe.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст