Jaguar XJ (X350). Manual — part 279
Power Steering Fluid Cooler (57.15.11)
Removal
All vehicles
1
.
Remove the Front Bumper Cover.
For additional information, refer to
Front Bumper Cover - VIN Range: G00442->H18679
(76.22.78)
2 . Remove the lower cowl.
3
.
CAUTION: If power steering fluid comes into contact with the paintwork, the
affected area must be immediately washed down with cold water.
CAUTION: Cap the power steering line to prevent loss of fluid and prevent dirt
ingress.
Disconnect the power steering fluid cooler lines.
Vehicles with supercharger
4 . Remove the power steering fluid cooler.
Vehicles without supercharger
5 . NOTE:
Left-hand shown, right-hand similar.
Remove the power steering fluid cooler.
Installation
1 . To install, reverse the removal procedure.
Tighten to 7 Nm.
www.
2
.
NOTE:
If the cooler is being replaced for leakage or noise related issues and there is no
evidence of fluid contamination, there is no need to replace the reservoir.
In some cases where the fluid clearly contains particulate matter, and the system continues to
function, flush the system with fresh fluid and replace the reservoir, as there is the possibility
that the reservoir internal filter may be damaged or faulty.
Power Steering Fluid Reservoir -
3.0L/3.5L/4.2L (57.15.08)
Removal
1
.
CAUTION: If power steering fluid comes into contact with the paintwork, the
affected area must be immediately washed down with cold water.
CAUTION: Cap the power steering lines to prevent loss of fluid and dirt ingress.
Detach the power steering fluid reservoir.
2
.
CAUTION: If power steering fluid comes into contact with the paintwork, the
affected area must be immediately washed down with cold water.
CAUTION: Cap the power steering lines to prevent loss of fluid and prevent dirt
ingress.
NOTE:
Drain fluid into a suitable container.
Remove the power steering fluid reservoir.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст