Jaguar XJ (X350). Manual — part 1027

Installation

1 . Install the alignment special tool to the crankshaft.

Align the special tool alignment peg to the timing hole on the crankshaft.

2

.

NOTE:

Install a new CKP ring.

NOTE:

Make sure that the CKP sensor ring is aligned correctly with the special tool pip and that

both mating surfaces are fully seated.

Install the CKP sensor ring to the installation special tool.

3 . NOTE:

Assemble the installation special tool to the alignment special tool.

Using the special tool, install the CKP sensor ring.

Tighten the special tool nut.

4 . Remove the installation special tool.

5

.

Remove the special tool retaining bolts and reposition into the threaded holes on the special

tool and tighten to remove the alignment special tool from the crankshaft.

6

.

CAUTION: Install the CKP sensor correctly into the housing. Failure to follow this

instruction may result in damage to the CKP sensor.

Install the crankshaft position (CKP) sensor.

www.

Tighten to 5 Nm.

7 . Install the flexplate.

For additional information, refer to Flexplate (12.53.13)

Engine Control Module (ECM) (18.30.01)

Removal

1 . Disconnect the battery ground cable.

For additional information, refer to Battery Disconnect and Connect

2 . Remove the cowl vent screen.

For additional information, refer to Cowl Vent Screen (76.10.01)

3 . Remove the washer reservoir filler neck.

4 . Remove the cabin air filter.

1) Detach the cabin air filter.

2) Remove the cabin air filter.

5 . Remove the cabin air filter housing.

www.