Jaguar XJ (X350). Manual — part 1026
7 . Detach the steering gear.
8 . Using suitable tie straps, secure the steering gear.
All vehicles
9 . Disconnect the crankshaft position (CKP) sensor electrical connector.
10 . Remove the CKP sensor blanking cover.
11 . NOTE:
The CKP sensor retaining bolt should not be removed from the CKP sensor.
Fully loosen the CKP sensor retaining bolt.
12 . Remove the CKP sensor.
Installation
1
.
CAUTION: Install the CKP sensor correctly into the housing. Failure to follow this
instruction may result in damage to the CKP sensor.
To install, reverse the removal procedure.
www.
2 . Tighten to 5 Nm.
3 . Tighten to 100 Nm.
4 . Tighten to 35 Nm.
Crankshaft Position (CKP) Sensor Ring
Special Service Tools
Installer - Timing Trigger Wheel
303-1130
Removal
1 . Remove the flexplate.
For additional information, refer to Flexplate (12.53.13)
2 . Remove the crankshaft position (CKP) sensor.
3 . Remove the CKP sensor ring.
Discard the CKP ring.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст