Jaguar XJ (X350). Manual — part 220
-> Yes
GO to Pinpoint Test
G531320t138
.
-> No
GO to Pinpoint Test
G531320t144
.
G531320t138 : CHECK THE PRIMARY RELEASE SWITCH SIGNAL CIRCUIT
FOR HIGH RESISTANCE
1.
Electric parking brake switch (TL82) connector disconnected. 2. Measure the resistance between:
CR50 connector, harness side
TL82 connector, harness side
Primary release switch signal 1 - pin 11 Primary release switch signal 1 - pin 04
•
Is the resistance less than 10 ohms?
-> Yes
GO to Pinpoint Test
G531320t139
.
-> No
REPAIR the high resistance circuit. For additional information, refer to the wiring diagrams.
G531320t139 : CHECK THE APPLY SWITCH RETURN CIRCUIT FOR HIGH
RESISTANCE
1. Measure the resistance between:
CR32 connector, harness side TL82 connector, harness side
Switch return - pin 06
Switch return - pin 06
•
Is the resistance less than 10 ohms?
-> Yes
GO to Pinpoint Test
G531320t140
.
-> No
INSTALL a new parking brake switch.
Parking Brake Switch (70.35.46)
G531320t140 : CHECK THE SWITCH RESISTANCE
1. Measure the resistance between:
TL82 connector, component side TL82 connector, component side
Switch release signal 1 - pin 04
Switch return - pin 06
•
Is the resistance between 595 and 611 ohms?
-> Yes
An intermittent fault may be present in the wiring harness. Visually check for chaffed wires or other
physical damage to the harness. If no fault is found in the circuit, suspect the following
component(s): - CR50 - CR32 - EPB module
-> No
INSTALL a new parking brake switch.
Parking Brake Switch (70.35.46)
G531320t141 : CHECK IF THE SHORT CIRCUIT IS IN THE HARNESS OR THE
SWITCH
1.
Electric parking brake switch (TL82) connector disconnected. 2. Measure the resistance between:
CR50 connector, component side Vehicle battery
www.
Release switch signal 1 - pin 11
Positive terminal
•
Is the resistance greater than 100 Kohms?
-> Yes
INSTALL a new parking brake switch.
Parking Brake Switch (70.35.46)
-> No
REPAIR the short circuit. For additional information, refer to the wiring diagrams.
G531320t142 : CHECK IF THE SHORT CIRCUIT IS IN THE HARNESS OR THE
SWITCH
1.
Electric parking brake switch (TL82) connector disconnected. 2. Measure the resistance between:
CR50 connector, component side Vehicle battery
Apply switch signal 1 - pin 10
Positive terminal
•
Is the resistance greater than 100 Kohms?
-> Yes
INSTALL a new parking brake switch.
Parking Brake Switch (70.35.46)
-> No
REPAIR the short circuit. For additional information, refer to the wiring diagrams.
G531320t143 : CHECK IF THE SHORT CIRCUIT IS IN THE HARNESS OR THE
SWITCH
1.
Electric parking brake switch (TL82) connector disconnected. 2. Measure the resistance between:
CR32 connector, component side Vehicle battery
Apply switch signal 2 - pin 02
Positive terminal
•
Is the resistance greater than 100 Kohms?
-> Yes
INSTALL a new parking brake switch.
Parking Brake Switch (70.35.46)
-> No
REPAIR the short circuit. For additional information, refer to the wiring diagrams.
G531320t144 : CHECK IF THE SHORT CIRCUIT IS IN THE HARNESS OR THE
SWITCH
1.
Electric parking brake switch (TL82) connector disconnected. 2. Measure the resistance between:
CR32 connector, component side Vehicle battery
Release switch signal 2 - pin 14
Positive terminal
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст