Jaguar XJ (X350). Manual — part 221

•

Is the resistance greater than 100 Kohms?

-> Yes

INSTALL a new parking brake switch.

Parking Brake Switch (70.35.46)

-> No

REPAIR the short circuit. For additional information, refer to the wiring diagrams.

Removal and installation

arking Brake Module - VIN Range:
G00442->G45703 (70.35.47)

Removal

1 . Remove the luggage compartment floor covering.

2 . Remove the luggage compartment side trim panel.

3 . Disconnect the parking brake module electrical connector.

4 . Disconnect the parking brake module electrical connector.

www.

5 . Remove the parking brake module.

Installation

1

.

NOTE:

If a new parking brake module is installed it must be configured using the Jaguar

approved diagnostic system.

To install, reverse the removal procedure.

Tighten to 4 Nm.

Parking Brake Module - VIN Range:
G45704->G99999 (70.35.47)

Removal

1 . Remove the luggage compartment floor covering.

2 . Remove the luggage compartment side trim panel.

3 . Detach the rear electronic module (REM).

4 . Disconnect the parking brake module electrical connectors.

www.