Jaguar XJ (X350). Manual — part 354
6 . Install the bucket tappet and shim assemblies.
Piston (12.17.02)
Disassembly
1
.
NOTE:
Mark the pistons to the original connecting rods to make sure correct installation
in the same cylinders from which they were removed.
Remove the top compression ring.
2 . Remove the second compression ring.
3 . Remove the first oil control ring.
4 . Remove the oil control spacer ring.
www.
5 . Remove the second oil control ring.
6
.
WARNING: The retaining rings have a tendency to spring out during
removal. Cover the end of the pin bore with a hand or a rag when removing the
retaining ring. Eye protection should be worn. Failure to follow these instructions
may result in personal injury.
Remove the retaining clips.
7 . Remove the piston pin and the connecting rod from the piston.
8
.
Clean and inspect the connecting rod and the piston. For additional information, refer
to <<303-00>>.
Assembly
1 . Install the piston pin.
•
Lubricate the piston pin and piston bore.
2 . Install the retaining clips.
3 . Check the piston ring end gap. For additional information, refer to <<303-00>>.
4 . Lubricate the piston and piston rings.
5 . Install the second oil control ring.
6 . Install the oil control spacer ring.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст