Jaguar XJ (X350). Manual — part 355
7 . Install the first oil control ring.
8
.
Install the second compression ring.
•
The top of the second compression ring has a "0" marked on it. Position this side
of the ring towards the top of the piston.
9 . Install the top compression ring.
•
The top compression ring can be installed with either side up.
Assembly
Engine
Special Service Tools
Wrench Strap-Universal
303-D055
Crankshaft Rear Seal Installer
303-178
Crankshaft Rear Seal Installer Adapter Bolts
303-384
Piston Ring Compressor
303-372
www.
Cylinder Bore Protector
303-535
Crankshaft Pulley Installer
303-102
Crankshaft Pulley Installer
303-335/2
Assembly
1
.
CAUTION: Use only plastic scraper when removing old gasket material.
Clean all the mating faces and reusable parts thoroughly and check for damage.
•
If gasket material remains on the cylinder head after cleaning, use a plastic tipped
scraper to remove remaining material.
2 . NOTE:
Never remove pipe plugs or alignment dowels unless they are to be serviced.
Reseal oil passage blanking plugs, as necessary.
3
.
NOTE:
The main bearings are precision selective fit. For additional information, refer to <<303-
00>>.
Install the upper crankshaft thrust washer.
•
Align assembly tab on thrust bearing to machining spot face on cylinder block.
4 . Install the upper crankshaft main bearings.
•
Lubricate the bearings and thrust washer.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст