Jaguar XJ (X350). Manual — part 404
23 . Remove the special tool from the left-hand cylinder head.
24 . Install the right-hand variable camshaft timing oil control unit housing.
Install new O-ring seals.
Tighten to 22 Nm.
25 . Raise the vehicle.
26 . Remove the special tool.
27 . Install the CKP sensor.
Tighten to 10 Nm.
28 . Connect the CKP sensor electrical connector.
29 . Lower the vehicle.
30 . Carry out the valve clearance check.
For additional information, refer to Valve Clearance Check (12.29.47)
31
.
Install the engine front cover.
For additional information, refer to Engine Front Cover - VIN Range: G45704->G99999
(12.65.01)
www.
Crankshaft Front Seal - VIN Range:
G00442->G45703 (12.21.14)
Special Service Tools
Installer, crankshaft front seal
303-750
Remover, crankshaft front seal
303-751
Removal
1 . Remove the crankshaft pulley.
For additional information, refer to
2 . Using the special tool, remove the crankshaft front seal.
Installation
1 .
CAUTION: Make sure the crankshaft front seal mating faces are clean and dry.
CAUTION: Do not remove the crankshaft front seal protector.
Using the special tool, install the crankshaft front seal.
2 . Remove the crankshaft seal protector.
3 . Install the crankshaft pulley.
For additional information, refer to
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст