Jaguar XJ (X350). Manual — part 477

8 . Attach the engine wiring harness.

1) Connect the VCT oil control solenoid electrical connector.

2) Attach the engine wiring harness.

9 . NOTE:

Vehicles with supercharger shown, vehicles without supercharger similar.

Attach the engine cover bracket.

Tighten to 6 Nm.

10 . Install the ignition coil-on-plug cover.

11 . Install the oil level indicator and tube.

Install a new O-ring seal.

Tighten to 6 Nm.

12

.

CAUTION: If power steering fluid comes into contact with the paintwork, the

affected area must be immediately washed down with cold water.

Attach the power steering fluid reservoir.

13 . Install the air cleaner.

For additional information, refer to Air Cleaner (19.10.05)

www.

Valve Cover RH - VIN Range: G00442-
>G45703 (12.29.44)

Removal

All vehicles

1 . NOTE:

Left-hand shown right-hand similar.

Remove the ignition coil-on-plug cover.

Vehicles without supercharger

2 . Remove the right-hand engine cover bracket.

3

.

Detach the engine wiring harness.

1) Detach the ground harness.

2)

Disconnect the variable camshaft timing (VCT) oil control solenoid electrical

connector.

3) Detach the engine wiring harness.

4 . Detach the right-hand engine wiring harness.

Vehicles with supercharger

5 . Detach the engine wiring harness.

Remove the retaining bolt.

6 . Detach the engine wiring harness.

www.