Jaguar XJ (X350). Manual — part 79
11 . Remove the circlip.
12 . Using the special tools, remove the bearing from the wheel knuckle.
Installation
1
.
CAUTION: The final tightening of the rear suspension components must be carried
out with the vehicle on its wheels.
Using the special tools, install the bearing to the wheel knuckle.
2 . Install the circlip.
3 . Using the special tools, install the wheel hub to the bearing.
4 . Install the wheel knuckle assembly.
Tighten to 90 Nm.
5
.
NOTE:
Using the old wheel hub nut tighten to 150 Nm.
NOTE:
Remove and discard the old wheel hub nut, install a new wheel hub nut tighten to 150
www.
Nm.
Attach the wheel knuckle to the halfshaft.
6 . Install the lower arm to the wheel knuckle.
7 . Install the outer tie rod retaining bolt.
8 . Install the ABS sensor.
Tighten to 10 Nm.
9
.
Install the brake disc.
For additional information, refer to
For additional information, refer to
For additional information, refer to
Brake Disc - Vehicles With: High Performance Brakes, VIN
Range: G00442->G45703 (70.10.10)
For additional information, refer to
Brake Disc - Vehicles With: High Performance Brakes, VIN
Range: G45704->G99999 (70.10.10)
10 . Tighten the wheel hub nut.
Tighten to 300 Nm.
11
.
CAUTION: The final tightening of the rear suspension components must be carried
out with the vehicle on its wheels.
Tighten to 150 Nm.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст