Jaguar XJ (X350). Manual — part 1495

3 . NOTE:

Right-hand shown, left-hand similar.

Disconnect the electrical connectors.

4 . NOTE:

Right-hand shown, left-hand similar.

Disconnect the electrical connector.

5

.

CAUTION: Make sure the rear window finisher insert is not bent on removal. Failure

to follow this instruction may result in damage to the component.

Remove the rear window finisher

6 . Apply protective tape around the rear rear window glass aperture.

7 . Apply suitable protective tape to rear edge of the headliner.

8 . Using a suitable long bladed tool, penetrate the windshield glass adhesive.

www.

9

.

Dispense 20 ml of WK9L lubricant into the WK9 spray bottle, fill the spray bottle with water

and mix.

10 . Apply cutting lubricant to the windshield glass adhesive.

11 . Prepare the cheese wire and cutting handle.

Cut a suitable length of cheese wire.

Install one of the cutting handles to the cheese wire.

12

.

Pass the free end of the cheese wire through the penetration and install the second cutting

handle.

13

.

WARNING: When removing the rear window glass, personal protection must be

worn. Failure to follow this instruction may result in personal injury.

CAUTION: Make sure the cheese wire cannot contacted the paintwork while the

the rear window glass adhesive is being cut. Failure to follow this instruction may result in

damage to the vehicle.

NOTE:

Apply cutting lubricant to the cheese wire frequently through out the cutting process.

With assistance and exercising care to avoid damaging the paintwork, cut around the rear

window glass commencing upwards and along the top.

14

.

Install the lifting handles to the window glass, with assistance carefully remove the rear

window glass from the vehicle.

15 . Remove the lifting handles from the rear windshield glass.

Installation

1

.

WARNING: If the rear window glass is being installed at a temperature of 23°C (73°F)

or above make sure the vehicle is not driven for at least 1 hour after installation. Failure to

follow this instruction may result in personal injury.

WARNING: If the rear window glass is being installed at a temperature of 11°C (52°F)

to 23°C (73°F), make sure the vehicle is not driven for at least 1.5 hours after installation.

Failure to follow this instruction may result in personal injury.

www.