Jaguar XJ (X350). Manual — part 1030

Engine Oil Pressure (EOP) Sensor

Removal

1 . Remove the oil filler cap.

2 . Remove the engine cover.

3 . Disconnect the engine oil pressure (EOP) sensor electrical connector.

4 . Remove the EOP sensor.

Installation

1 . To install, reverse the removal procedure.

Tighten to 15 Nm.

www.

Fuel Rail Pressure (FRP) Sensor (18.30.98)

1
.

The fuel rail pressure sensor is removed as part of the fuel diverter rail and can not be
serviced separately.
For additional information, refer to Fuel Diverter Rail

Fuel Temperature Sensor (18.30.99)

Removal

WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working

on or near any fuel related components. Highly flammable mixtures are always present and may

ignite. Failure to follow these instructions may result in personal injury. This procedure involves

fuel handling. Be prepared for fuel spillage at all times and always observe fuel handling

precautions. Failure to follow these instructions may result in personal injury. Do not carry out any

repairs to the fuel injection system with the engine running. The fuel pressure within the system

can be as high as 1600 bar. Failure to follow this instruction may result in personal injury. Do not

carry out any repairs to the fuel injection system without checking that the fuel pressure has

dropped to zero. Failure to follow this instruction may result in personal injury. Wait at least one

minute after the engine stops before commencing any repair to the fuel injection system. Failure

to follow this instruction may result in personal injury. CAUTIONS:

CAUTION: Make sure the workshop area in which the vehicle is being worked on is as clean

and as dust free as possible. Foreign matter from work on clutches, brakes or from machining or

welding operations can contaminate the fuel system and may result in later malfunction. Always

carry out the cleaning process before carrying out any repairs to the fuel injection system

components. Failure to follow this instruction may result in foreign matter ingress to the fuel

injection system. Diesel fuel injection equipment is manufactured to very precise tolerances and

fine clearances. It is therefore essential that absolute cleanliness is observed when working with

these components. Always install blanking caps to any open orifices or lines.

1 . Remove the oil filler cap.

2 . Remove the engine cover.

www.