Range Rover Body Repair Manual — part 24
CHASSIS AND BODY
21
REPAIR
7. Remove bolt securing pipe clamp to thermostatic
expansion valve (TXV) and release pipes.
8. Remove and discard ’O’ ring seals from air
conditioning pipes.
9. Immediately cap both air conditioning pipes and
TXV ports to prevent moisture entering the air
conditioning system.
10. Remove wiper motor and linkage.
See WIPERS
AND WASHERS, Repair.
11. Disconnect passenger side heated screen
multiplug.
12. Release heated screen multiplug from scuttle
side panel and position aside.
13. Remove 6 bolts securing scuttle side panel to
scuttle and remove panel.
14. Remove pollen filter from both heater intake
housings.
15. Remove 8 screws securing each heater intake
housing to scuttle and remove intake housings.
Release sealing rubbers from scuttle panel
aperture.
16. Remove centre console.
See this section.
17. Remove transmission tunnel insulation pad.
76
CHASSIS AND BODY
NEW RANGE ROVER
22
REPAIR
18. Release latching mechanism and disconnect
multiplug from airbag diagnostic and control unit
(DCU).
19. Release SRS harness from transmission tunnel
and position to fascia to avoid snagging.
20. Remove 6 nuts securing gear lever gaiter ring to
transmission tunnel and release gaiter.
21. Remove 2 bolts securing gear lever to gearbox
remote and remove gear lever.
22. Disconnect high/low switch multiplug.
23. Remove 4 bolts securing fascia centre bracket to
fascia and transmission tunnel.
24. Remove fascia centre bracket.
25. Remove radio.
See ELECTRICAL, Repair.
26. Remove steering column.
See STEERING,
Repair.
CHASSIS AND BODY
23
REPAIR
27. Remove 3 scrivets securing lower fascia closing
panel to passenger’s side of fascia.
28. Release closing panel and release diagnostic
connector from panel.
29. Release door aperture seal adjacent to ’A’ post
lower trim panels.
30. Remove screw securing each ’A’ post lower trim
panel to ’A’ post.
31. Release ’A’ post lower trim panels from sprag
clip and remove panels.
32. Remove fuse box cover from driver’s seat base
trim.
33. Remove screw and 3 trim studs securing seat
base trim to body and remove seat base trim.
34. Release 4 sprag clips securing driver’s side
carpet retainer to body and remove carpet
retainer.
35. Disconnect 3 multiplugs from Body Electrical
Control Module (BeCM).
36. Position carpet aside and disconnect multiplug
from rear of BeCM.
76
CHASSIS AND BODY
NEW RANGE ROVER
24
REPAIR
37. Remove captive nut securing earth wires to
driver’s side lower ’A’ post and release 3
additional earth wires.
38. Disconnect 3 multiplugs at base of driver’s side
’A’ post.
39. Release harness from driver’s side carpet and
position to fascia to avoid snagging.
40. Disconnect multiplugs from clutch and 2 brake
pedal switches.
41. Disconnect vacuum hose from clutch and brake
pedal switches.
42. Disconnect 2 multiplugs at base of passenger’s
side ’A’ post.
43. Remove 2 nuts securing fascia to ’A’ post and
transmission tunnel bracket, passenger’s side
44. Remove 2 nuts securing fascia to ’A’ post and
transmission tunnel bracket, driver’s side.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст