Range Rover Body Repair Manual — part 36
CHASSIS AND BODY
69
REPAIR
TAILGATE LATCH
Service repair no - 76.37.17
Remove
1. Release studs securing tailgate board. Remove
board.
2. Release clips securing operating rods to tailgate
centre latch. Release rods.
3. Disconnect latch multiplug.
4. Remove 2 bolts securing latch to tailgate.
Remove latch.
Refit
5. Reverse removal procedure.
TAILGATE LATCH - OUTER
Service repair no - 76.37.73
Remove
1. Release studs securing tailgate board. Remove
board.
2. Release clip securing outer latch rod. Disconnect
rod from centre latch.
76
CHASSIS AND BODY
NEW RANGE ROVER
70
REPAIR
3. Remove 2 bolts securing outer latch to tailgate.
Remove latch and rod.
4. Rotate release rod 90˚ to remove from outer
latch.
Refit
5. Reverse removal procedure.
UPPER TAILGATE - INTERIOR TRIM
Service repair no - 76.34.13
Remove
Lower trim assembly
1. Release load space lamp from trim panel,
disconnect 2 Lucar terminals and remove lamp.
2. Remove 6 screws securing trim panel to side
trims and tailgate.
3. Release 4 studs securing trim panel to tailgate.
4. Disconnect high level stop lamp multiplug, if
fitted.
5. Remove lower trim assembly.
Upper trim
6. Remove 6 screws securing trim panel to tailgate.
CHASSIS AND BODY
71
REPAIR
7. Remove trim panel and collect 2 foam pads.
Side trims
8. Release 3 studs securing each side trim.
9. Remove 2 side trims.
Refit
10. Reverse removal procedure.
TAILGATE STRUT
Service repair no - 76.40.33
Remove
1. Secure tailgate in open position using suitable
support.
2. Release clips securing strut to ball joints.
Remove strut.
Refit
3. Reverse removal procedure.
76
CHASSIS AND BODY
NEW RANGE ROVER
72
REPAIR
WHEEL ARCH LINER - FRONT
Service repair no - 76.10.48
Remove
1. Raise the vehicle.
WARNING: Support on safety stands.
2. Remove relevant road wheel.
3. Remove 3 screws securing mud flap. Remove
mud flap.
4. Remove 8 studs securing wheel arch liner.
Refit
5. Position liner and secure with trim studs.
6. Fit mud flap and secure with screws.
7. Refit road wheel. Secure with nuts. Tighten to
108 Nm. (80 lbf.ft)
8. Remove safety stands. Lower vehicle.
WHEEL ARCH LINER - REAR
Service repair no - 76.10.49
Remove
1. Raise the vehicle.
WARNING: Support on safety stands.
2. Remove relevant road wheel.
3. Remove screws from wheel arch liner fixings.
Remove fixings.
4. Remove liner.
Refit
5. Position liner. Fit liner fixings. Secure with
screws.
6. Refit road wheel. Secure with nuts. Tighten to
108 Nm. (80 lbf.ft)
7. Remove safety stands. Lower vehicle.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст