Discovery 2. Manual — part 732
LIGHTING
REPAIRS
86-2-9
Motor - headlamp levelling
$% 86.41.16
Remove
1. For RH headlamp levelling motor: Release
fixings and remove battery cover.
2. Remove headlamp access cover.
3. Release headlamp from adjuster pin sockets.
4. Rotate and remove motor from body panel.
5. Disconnect multiplug from motor.
6. Remove headlamp levelling motor.
Refit
1. Position new headlamp levelling motor and
connect multiplug.
2. Fit motor to body panel.
3. Fit headlamp to adjuster pins.
4. Check headlamp beam alignment.
Headlamps beam alignment - up to 03MY.
5. Fit headlamp access cover.
6. For RH headlamp levelling motor: Fit and
secure battery cover with fixings.
LIGHTING
86-2-10 REPAIRS
Lamp - stop - centre high mounted
(CHMSL)
$% 86.41.32
Remove
1. Remove 2 screws securing lamp cover and
remove cover.
2. Disconnect Lucar connectors from lamp bulb
holder.
3. Remove 2 nuts securing lamp to rear screen
and remove lamp.
Refit
1. Fit new lamp to screen and secure with nuts.
2. Connect Lucar connectors to lamp bulb holder.
3. Fit lamp cover to lamp and secure with screws.
Lamp - tail/flasher - bumper
$% 86.41.42
Remove
1. Release tail lamp from bumper.
2. Disconnect multiplug and remove lamp.
Refit
1. Position tail lamp, connect multiplug and
secure lamp to bumper.
LIGHTING
REPAIRS 86-2-11
Lamp - interior - front
$% 86.45.09
Introduction
This procedure is also applicable for removal and
fitting of the loadspace lamp.
Remove
1. Remove interior lamp lens.
2. Remove two nuts securing lamp.
3. Release lamp and disconnect multiplug.
4. Remove lamp.
Refit
1. Position new lamp and connect multiplug.
2. Fit lamp and secure with nuts.
3. Fit interior lamp lens.
Lamp - interior - rear
$% 86.45.18
Remove
1. Release lamp from headlining.
2. Disconnect multiplug and remove lamp.
Refit
1. Position interior lamp and connect multiplug.
2. Fit lamp to headlining.
LIGHTING
86-2-12 REPAIRS
Rheostat - panel lights dimmer
$% 86.65.37
Remove
1. Remove 2 screws securing instrument cowl to
fascia and release the cowl from the retaining
clips.
2. Disconnect 8 multiplugs from the instrument
cowl switches.
3. Remove the instrument cowl.
4. Remove 2 screws securing the dimmer switch
to the instrument cowl and remove the dimmer
switch.
Refit
1. Fit the dimmer switch to the instrument cowl
and secure with screws.
2. Position the instrument cowl to the fascia and
connect the multiplugs.
3. Fit the instrument cowl to the fascia and secure
with screws.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст