Discovery 2. Manual — part 675
CHASSIS AND BODY DIMENSIONS
CHASSIS DIMENSIONS
77-1-3
Chassis dimensions - front end
Plan view
Side view
Figures shown outside brackets are metric measurements (millimetres) and those inside brackets are imperial
measurements (inches).
CHASSIS AND BODY DIMENSIONS
77-1-4
CHASSIS DIMENSIONS
Chassis dimensions - rear end
Plan view
Side view
Figures shown outside brackets are metric measurements (millimetres) and those inside brackets are imperial
measurements (inches).
CHASSIS AND BODY DIMENSIONS
BODY DIMENSIONS
77-1-5
BODY DIMENSIONS
Body Dimensions
The following dimensional information is shown to assist the technician in the diagnosis and repair of body panels.
The information is shown in two different forms. In the first part of the information X,Y and Z dimensions are shown
and in the second part actual point to point dimensions are shown.
The X,Y,Z dimensions are the planes used by Land Rover for the measurement of body panels. The whole bodyshell
lies within a parallel grid system. See following illustrations.
The 'X' plane is an imaginery vertical plane which measures distances along the length of the vehicle. The start point
for this plane is through the centre of the rear wheels.
The 'Y' plane is an imaginery plane through the centre of the vehicle and measures distances across the vehicle. As
a rule, body dimensions are symmetrical about the centre line.
M77 1757
-2400
(-94.488)
X
-1800
(-70.866)
-1200
-600
0
600
(-47.244)
(-23.622)
(23.622)
X
X
X
X
X
1200
(47.244)
Z
600
(23.622)
Z
0
Z
M77 1756
0
Y
600
(23.622)
Y
600
(23.622)
Y
CHASSIS AND BODY DIMENSIONS
77-1-6
BODY DIMENSIONS
The 'Z' plane is an imaginery horizontal plane which measures distances in height of the vehicle. The start point for
this plane is through the centre of the rear wheels.
The point to point dimensional information shown are actual distances between two points. These points used are
either intersection points or holes. Where holes are taken, the point of measurement is always from the hole centre.
X,Y,Z dimensional information
Figures shown outside brackets are metric measurements (millimetres) and those inside brackets are imperial
measurements (inches).
Body to chassis mounting holes
I.D
Description
X
Y
Z
A
Front mounting hole
-3071.6
419.1
271.5
(-120.929)
(16.500)
(10.688)
B
Second mounting hole
-2130.5
414.3
233.4
(-83.877)
(16.311)
(9.188)
C
Third mounting hole
-1763.7
660.4
78.0
(-69.437)
(26.000)
(3.070)
D
Fourth mounting hole
-1055.6
414.3
169.8
(-41.559)
(16.311)
(6.685)
E
Fifth mounting hole
-552.3
660.4
78.0
(-21.744)
(26.000)
(3.070)
F
Sixth mounting hole
-44.000
275.0
296.4
(-1.732)
(10.826)
(11.669)
G
Rear mounting hole
925.6
495.3
184.6
(36.440)
(19.500)
(7.267)
M77 1759
A
B
C
D
E
F
G
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст