Discovery 2. Manual — part 728
WIPERS AND WASHERS
REPAIRS
84-27
Switch - wiper - rear - up to 03MY
$% 84.35.33
Remove
1. Carefully remove switch from instrument cowl.
2. Disconnect multiplug and remove switch.
Refit
1. Position new switch and connect multiplug.
2. Carefully push switch into instrument cowl.
Switch - wiper - rear - from 03MY
$% 843533
Remove
1. Remove 2 screws securing instrument cowl to
fascia and release the cowl from the retaining
clips.
2. Disconnect multiplug from the rear wiper
switch.
3. Remove the rear wiper switch from the
instrument cowl.
Refit
1. Fit and secure the rear wiper switch to the
instrument cowl and connect the multiplug.
2. Fit the instrument cowl to the fascia and secure
with screws.
WIPERS AND WASHERS
84-28
REPAIRS
CHARGING AND STARTING
REPAIRS
86-1-1
CHARGING AND STARTING
REPAIRS
Alternator - diesel
$% 86.10.02
Remove
1. Remove auxiliary drive belt.
REPAIRS, Belt - auxiliary drive.
2. Release cover and remove nut securing lead
to alternator.
3. Disconnect alternator multiplug.
4. Remove bolt (LH thread) and remove auxiliary
drive belt tensioner.
5. Remove bolt securing support stay to
alternator.
6. Release clip and disconnect oil drain hose from
vacuum pump.
7. Disconnect vacuum pump oil supply pipe from
cylinder head and discard 'O' ring.
8. Remove bolt securing alternator and release
from mounting bracket.
9. Disconnect vacuum hose from vacuum pump.
10. Remove alternator. Take care not to damage
radiator cooling fins.
11. Remove 4 bolts, and remove vacuum pump
from alternator.
CAUTION: Always fit plugs to open
connections to prevent contamination.
CHARGING AND STARTING
86-1-2
REPAIRS
Refit
1. Clean mating faces of alternator and vacuum
pump.
2. Fit vacuum pump to alternator and tighten
bolts to 8 Nm (6 lbf.ft).
3. Position alternator to engine and connect
multiplug.
4. Connect vacuum hose and oil drain hose to
vacuum pump and secure clips.
5. With assistance align alternator to mounting
bracket and fit but do not tighten bolt.
6. Fit bolt securing support stay to alternator and
tighten to 25 Nm (18 lbf.ft) .
7. Tighten bolt securing alternator to mounting
bracket to 45 Nm (33 lbf.ft).
8. Using new 'O' ring, connect oil supply pipe to
cylinder head and tighten to 10 Nm (7 lbf.ft).
9. Connect lead to alternator and tighten nut to 6
Nm (4.4 lbf.ft).
10. Fit auxiliary drive belt tensioner and tighten bolt
to 50 Nm (37 lbf.ft).
11. Fit auxiliary drive belt.
REPAIRS, Belt - auxiliary drive.
Alternator - V8
$% 86.10.02
Remove
1. Remove auxiliary drive belt.
REPAIRS, Belt - auxiliary drive.
2. Remove 2 bolts securing alternator to
mounting bracket.
3. Release alternator from mounting bracket
4. Remove nuts securing alternator cables, and
release cables.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст