Discovery 2. Manual — part 92

ENGINE MANAGEMENT SYSTEM - V8

REPAIRS 18-2-97

Switch - cruise control (set/resume)

$% 19.75.33

Remove

1. Remove the key from the starter switch.

Disconnect both battery leads, negative lead
first. Wait ten minutes before starting work.

2. Remove driver's airbag module.

+

RESTRAINT SYSTEMS, REPAIRS,

Airbag module - drivers.

3. Release remote control switches multiplug and

leads from steering wheel base.

4. Disconnect remote control switches multiplug

from harness.

5. Remove 2 screws securing remote control

switches to steering wheel base.

6. Release and remove remote control switches

from steering wheel.

Refit

1. Fit remote control switches to steering wheel

and secure with screws.

2. Connect remote control switches multiplug to

harness.

3. Secure leads and multiplug to base of steering

wheel.

4. Fit driver's airbag module.

+

RESTRAINT SYSTEMS, REPAIRS,

Airbag module - drivers.

Switch - clutch pedal - cruise control

$% 19.75.34

Remove

1. Remove 3 fasteners and move driver's side

lower closing panel aside.

2. Disconnect multiplug from clutch pedal switch.
3. Remove switch from pedal bracket.

Refit

1. Engage switch fully into pedal bracket location

and connect multiplug.

2. Position lower closing panel and secure with

fasteners.

ENGINE MANAGEMENT SYSTEM - V8

18-2-98 REPAIRS

ECU - Cruise control

$% 19.75.49

Remove

1. Remove fixings securing fascia RH closing

panel and remove panel.

2. Remove 2 fixings and remove 'A' post lower

trim.

3. Remove 2 nuts and remove ECU from studs.
4. Disconnect multiplug from ECU and remove

ECU.

Refit

1. Position new ECU and connect multiplug.
2. Fit ECU to studs and secure with nuts.
3. Fit lower trim panel to 'A' post and secure with

fixings.

4. Fit closing panel and secure with fixings.
5. Programme the ECU using TestBook.

FUEL DELIVERY SYSTEM - V8

DESCRIPTION AND OPERATION

19-2-1

FUEL DELIVERY SYSTEM - V8

DESCRIPTION AND OPERATION

Fuel delivery system

1 Fuel pressure regulator (hidden)
2 Schraeder valve
3 Fuel rail
4 Injectors
5 Engine block

6 Fuel feed pipe
7 Coarse filter
8 Fine filter
9 Fuel pump and fuel gauge sender assembly

FUEL DELIVERY SYSTEM - V8

19-2-2

DESCRIPTION AND OPERATION

Fuel tank and breather components (all
except NAS)

1 Fuel filler cap
2 Relief valve
3 Vent to EVAP canister
4 Tank breather connection
5 Fuel pump, regulator and fuel gauge sender

assembly

6 Seal
7 Locking ring
8 Fuel feed connection
9 Fuel gauge sender float

10 Fuel tank and breather assembly
11 Heat shield
12 Scrivet 2 off

13 Stud plate
14 Nut 2 off
15 Cradle
16 Bolt 2 off
17 Nut plate 2 off
18 Hose clip 2 off
19 Hose
20 Vent hose
21 Vent hose coupling
22 Hose clip 2 off
23 Hose
24 Filler tube
25 Liquid Vapour Separator (LVS)