Range Rover. Manual — part 30
BMW DIESEL
11
REPAIR
37. With assistance, remove radiator/condenser
assembly.
Manual Vehicles:
38. Clamp clutch flexible hose using approved brake
hose clamp.
39. Remove clip securing flexible hose to gearbox
bracket.
40. Disconnect clutch flexible hose at gearbox pipe.
Position hose aside.
41. Remove centre console.
See CHASSIS AND
BODY, Repair.
42. Remove 6 nuts securing gaiter ring. Remove
ring and gaiter.
43. Remove 2 bolts securing gear lever. Remove
lever.
Automatic Vehicles:
44. Remove window switch pack.
See
ELECTRICAL, Repair.
12
ENGINE
NEW RANGE ROVER
12
REPAIR
All Vehicles:
45. Release handbrake. Remove handbrake cable
clevis pin.
46. Raise lift. Drain gearbox, transfer box and
engine fluids.
See SECTION 10, Maintenance.
47. Using a transmission jack, support transmission
under brake drum.
48. Remove chassis cross member.
See CHASSIS
AND BODY, Repair.
Remove exhaust front pipe.
See MANIFOLD
AND EXHAUST SYSTEM, Repair.
49. Release hand brake cable from grommet in
tunnel.
50. Remove 4 bolts securing rear propeller shaft
guard. Remove guard.
51. Mark positions of propeller shafts and transfer
box flanges to aid reassembly.
52. Raise one wheel on each axle to allow rotation
of propeller shafts.
53. Remove 4 nuts from rear flange and 4 nuts and
bolts from front flange. Disconnect propeller
shafts. Tie aside.
54. Lower gearbox for access.
BMW DIESEL
13
REPAIR
Automatic Vehicles:
55. Disconnect gear selector cable trunnion from
gearbox lever. Remove 2 bolts securing selector
cable abutment bracket to gearbox.
56. Place selector cable aside.
57. Disconnect multiplugs from gear selection
position switch and gearbox speed sensor.
All Vehicles:
58. Disconnect 2 Lucars from transfer box fluid
temperature sensor.
59. Disconnect multiplugs from High/Low motor and
output shaft speed sensor.
12
ENGINE
NEW RANGE ROVER
14
REPAIR
Manual Vehicles:
60. Disconnect multiplugs from reverse and neutral
switches. Remove bolt securing harness bracket
to gearbox. Release harness from clips on
gearbox brackets.
All Vehicles:
61. Disconnect engine harness to gearbox harness
multiplug. Position harness aside.
62. Remove 4 nuts securing each engine mount to
engine bracket.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст