Range Rover. Manual — part 283
HEATING AND VENTILATION
5
REPAIR
Refit
Blend and Distribution Servos.
11. Reverse removal procedure.
Recirculation Flap Servos.
12. Hold flap in ’fresh air’ position.
13. Position servo. Engage drive gear with flap gear.
14. Secure servo with screws. Connect multiplug.
Secure plug to casing.
15. Fit fascia assembly.
See CHASSIS AND
BODY, Repair.
80
HEATING AND VENTILATION
NEW RANGE ROVER
6
REPAIR
HEATER MATRIX
Service repair no - 80.20.29
Remove
1. Remove heater unit.
See this section.
2. Remove 2 screws securing duct to RH side of
heater. Remove duct.
3. Remove screw securing heater pipe bracket.
4. Remove 2 screws securing RH servo to heater
casing. Remove servo.
5. Release 2 clips securing matrix to heater.
Remove matrix and pipe assembly.
NOTE: Matrix has provision for 2 screws in
the event that the retaining clips break.
6. Remove 2 screws securing pipes to matrix.
Remove pipe assembly.
7. Remove and discard ’O’ rings from pipe
assembly.
Refit
8. Lubricate new ’O’ rings with anti freeze. Fit to
pipes.
9. Reverse removal procedure.
HEATING AND VENTILATION
7
REPAIR
BLOWER MOTOR
Service repair no - 80.20.15
Remove
1. Remove glove box assembly.
See CHASSIS
AND BODY, Repair.
2. Release 2 clips securing fascia harness trunking
to fascia frame.
3. Remove centre screws from 4 scrivet fasteners
securing drivers side lower closing panel.
4. Release panel for access to harness clip. Collect
outer parts of fasteners from closing panel.
5. Remove upper fascia closing panel.
See
CHASSIS AND BODY, Repair.
6. Release clip securing harness trunking to fascia
frame.
7. Remove 2 bolts securing cruise control ECU
bracket to fascia frame. Place bracket aside.
8. Release SRS harness connector from bracket.
Position harness aside.
9. Disconnect Lucar connector and multiplug from
blower motor.
80
HEATING AND VENTILATION
NEW RANGE ROVER
8
REPAIR
10. Remove 4 screws securing blower motor to
casing.
11. Remove motor and fan assembly. Do not stress
fascia harness.
Refit
12. Reverse removal procedure.
BLEND FLAP SERVOS - HEATER ONLY
Service repair no - 80.20.04
NOTE: This procedure applies to non air
conditioned vehicles. For air conditioned
vehicles.
See this section.
Remove
1. Open glove box. Remove 5 screws securing
glove box liner to fascia.
2. Release glove box liner. Disconnect lamp
multiplug.
3. Release cable from glove box latch.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст