Range Rover. Manual — part 284
HEATING AND VENTILATION
9
REPAIR
4. Lower glove box liner from fascia gaining access
to servo.
5. Drivers Side. Remove fascia closing panel.
See CHASSIS AND BODY, Repair.
6. Remove radio.
See ELECTRICAL, Repair.
7. Remove heater control panel.
See this section.
8. Release fascia switch pack. Position aside.
See
ELECTRICAL, Repair.
9. Remove 4 bolts securing fascia centre support
plate to transmission tunnel and fascia.
10. Remove 2 harness clamps.
11. Identify relevant pins in servo harness
connector. Release 2 locking tags on rear of
connector.
12. Release relevant pins from connector by
inserting thin probe into front face as shown.
13. Remove 2 screws securing servo to heater
casing. Remove servo.
80
HEATING AND VENTILATION
NEW RANGE ROVER
10
REPAIR
Refit
14. Reverse removal procedure.
HEATER AND AIR CONDITIONING CONTROLS
Service repair no - 80.10.02
Remove
1. Move front seats to rearmost positions.
2. Remove 2 screws securing each side panel to
centre console. Release sprag clips from fascia
switch pack. Remove side panels.
3. Remove 4 screws securing control panel to
fascia. Release panel.
HEATING AND VENTILATION
11
REPAIR
4. Disconnect multiplugs. Remove control panel.
Refit
5. Reverse removal procedure.
PLENUM AIR INTAKE PANELS
Service repair no - 80.15.62
Remove
1. Remove windscreen lower finisher.
See
CHASSIS AND BODY, Repair.
2. Remove 3 screws securing each outer plenum
panel.
3. Remove RH plenum panel.
4. Raise LH plenum panel. Disconnect bonnet
harness multiplug.
5. Release harness sleeve from panel. Remove LH
plenum panel.
6. Remove 8 screws securing centre plenum panel.
Remove panel
Refit
7. Reverse removal procedure.
80
HEATING AND VENTILATION
NEW RANGE ROVER
12
REPAIR
POLLEN FILTER
Service repair no - 80.15.42
Remove
1. Remove 2 screws securing each pollen filter
cover.
2. Remove pollen filter covers.
3. Remove pollen filters.
Refit
4. Reverse removal procedure.
PIPE - HEATER - FEED
Service repair no - 80.25.07
Remove
1. Remove heater return pipe.
See this section.
2. Release clip securing heater feed hose to heater
feed pipe and disconnect hose from pipe.
3. Remove nut securing heater feed pipe to plenum
chamber.
4. Press quick release connector and release
heater feed pipe from plenum chamber.
5. Remove and discard ’O’ ring from pipe.
Refit
6. Fit new ’O’ ring to heater feed pipe and lubricate
with castor oil.
7. Secure heater feed pipe to plenum chamber.
8. Fit and tighten nut securing heater feed pipe to
plenum chamber.
9. Connect heater feed hose to heater feed pipe
and secure with clip.
10. Fit heater return pipe.
See this section.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст