Range Rover. Manual — part 315
ELECTRICAL
1
REPAIR
ALTERNATOR DRIVE BELT - V8 - UP TO 99MY
Service repair no - 86.10.03
Remove
1. Disconnect battery negative lead.
2. Release 2 clips securing fan cowl. Remove cowl.
3. Rotate tensioner to release tension from
alternator drive belt.
4. Remove drive belt.
Refit
5. Reverse removal procedure.
86
ELECTRICAL
NEW RANGE ROVER
2
REPAIR
ALTERNATOR DRIVE BELT - V8 - FROM 99MY
Service repair no - 86.10.03
Remove
1. Remove cooling fan.
See COOLING SYSTEM,
Repair.
2. Remove 2 bolts securing auxiliary drive belt
cover, remove cover and collect spacers.
3. Release drive belt tensioner using a 15 mm ring
spanner and remove belt from pulleys.
Refit
4. Clean drive belt pulley grooves and ensure
grooves are not damaged.
5. Fit new drive belt around pulleys, ensure belt is
correctly aligned in pulley grooves.
6. With assistance, hold tensioner fully clockwise
and fit drive belt around remaining pulley.
7. Fit auxiliary drive belt cover and spacers and
secure with bolts.
8. Fit cooling fan.
See COOLING SYSTEM,
Repair.
ELECTRICAL
3
REPAIR
ALTERNATOR DRIVE BELT - DIESEL
Service repair no - 86.10.03
Remove
1. Disconnect battery negative lead.
2. Remove air conditioning compressor drive belt,
See AIR CONDITIONING, Repair.
3. Remove 3 bolts securing upper fan cowl.
Remove fan cowl.
4. Release belt tension using a suitable lever
beneath tensioner damper as shown.
5. Release belt from pulleys. Withdraw belt from
between cooling fan and cowl.
Refit
6. Ensure belt surfaces of pulleys are clean.
7. Thread belt between cooling fan and cowl.
8. Route belt around pulleys as shown.
9. Finally, lever tensioner to slack position. Engage
belt over alternator pulley.
10. Position upper fan cowl. Secure with bolts.
11. Fit air conditioning compressor drive belt.
See
AIR CONDITIONING, Repair. Reconnect
battery negative lead.
86
ELECTRICAL
NEW RANGE ROVER
4
REPAIR
ALTERNATOR - V8 - UP TO 99MY
Service repair no - 86.10.02
Remove
1. Disconnect battery negative lead.
2. Remove alternator drive belt.
See this section.
3. Remove 2 bolts securing alternator to mounting
bracket.
4. Release alternator from mounting bracket to gain
access to terminal cover.
5. Remove terminal cover.
6. Remove 2 nuts securing leads to alternator
terminals. Remove leads.
7. Remove alternator.
Do not carry out further dismantling if
component is removed for access only.
8. Restrain shaft using an Allen key. Remove
pulley nut. Remove pulley.
9. Ensure shaft and pulley are clean.
10. Position pulley. Secure with nut. Tighten to
40 Nm. (30 lbf.ft)
Refit
11. Position alternator.
12. Fit 2 leads to alternator. Secure with nuts. Fit
terminal cover.
13. Align alternator to mounting bracket. Secure with
bolts. Tighten to
25 Nm. (18 lbf.ft)
14. Fit alternator drive belt.
See this section.
15. Reconnect battery negative lead.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст