Range Rover. Manual — part 303
WIPERS AND WASHERS
5
REPAIR
REAR WIPER MOTOR
Service repair no - 84.35.12
Remove
1. Remove wiper arm nut cover. Remove nut.
2. Remove wiper arm from motor spindle.
3. Remove motor spindle cover, retaining nut and
seal.
4. Open tailgate.
5. Remove 6 screws securing wiper motor cover.
6. Disconnect motor multiplug.
7. Remove 2 bolts securing motor. Remove motor.
8. Remove 4 bolts securing mounting plate to
motor.
9. Release multiplug holder. Remove mounting
plate.
10. Remove sealing rubber from motor spindle.
84
WIPERS AND WASHERS
NEW RANGE ROVER
6
REPAIR
Refit
11. Fit sealing rubber to motor spindle.
12. Fit mounting plate. Secure with bolts.
13. Connect multiplug holder to mounting plate.
14. Position motor. Secure with bolts. Tighten to
7 Nm (5 lbf.ft)
15. Connect multiplug.
16. Position motor cover. Secure with screws.
17. Close tailgate.
18. Fit motor spindle seal. Fit retaining nut. Tighten
to
4 Nm (3 lbf.ft). Fit cover.
19. Position wiper arm. Secure with retaining nut.
Tighten to
17 Nm (12 lbf.ft). Fit cover.
WASHER JET - FRONT
Service repair no - 84.10.08
Remove
1. Disconnect washer tube elbow from base of jet.
2. Remove jet from retainer.
3. Remove retainer.
Refit
4. Reverse removal procedure.
WIPERS AND WASHERS
7
REPAIR
WASHER JET - REAR
Service repair no - 84.30.09
Remove
1. Prise washer jet from tailgate.
CAUTION: Do not use a metal lever, or
painted surface may be damaged.
2. Remove washer jet from tube.
Refit
3. Reverse removal procedure.
WASHER PUMP
Service repair no - 84.10.21
Remove
1. Raise the vehicle.
WARNING: Support on safety stands.
2. Release washer reservoir for access.
See this
section.
3. Drain washer fluid into a suitable container.
4. Disconnect pump multiplug and hose.
5. Remove pump from reservoir. Collect seal and
discard.
Refit
6. Fit seal and pump to reservoir.
7. Connect multiplug and hose.
8. Refit washer reservoir.
See this section.
9. Remove safety stands. Lower vehicle.
84
WIPERS AND WASHERS
NEW RANGE ROVER
8
REPAIR
WASHER RESERVOIR
Service repair no - 84.10.01
Remove
1. Raise the vehicle.
WARNING: Support on safety stands.
2. Remove RH wheel arch liner.
See CHASSIS
AND BODY, Repair.
3. Remove bolt and screw securing filler neck to
chassis and radiator bracket.
4. Remove filler neck.
5. Remove 2 bolts securing reservoir to chassis.
6. Release reservoir from mounting for access to
washer pumps.
7. Disconnect multiplugs and hoses from 3 washer
pumps.
8. Disconnect fluid level indicator multiplug.
9. Remove washer pumps and seals from
reservoir.
10. Remove filler neck seal.
Refit
11. Reverse removal procedure.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст