Range Rover. Manual — part 302
WIPERS AND WASHERS
1
REPAIR
HEADLAMP WIPER BLADE, ARM & WASHER JET
Service repair no - 84.25.06 - Blade
Service repair no - 84.25.02 - Arm
Blade
1. Lift wiper arm away from headlamp.
2. Remove wiper blade.
Arm and Washer jet Assembly
3. Lift cover. Remove nut securing arm to spindle.
4. Disconnect hose from washer jet.
5. Remove wiper arm/jet assembly from spindle.
Refit
6. Connect washer tube to jet.
7. Ensure wiper arm is in ’park’ position.
8. Position wiper arm to spindle. Set wiper arm
horizontal.
9. Secure wiper arm with nut. Tighten to
10 Nm
(7 lbf.ft). Secure cover.
Blade
10. Clip blade into wiper arm.
84
WIPERS AND WASHERS
NEW RANGE ROVER
2
REPAIR
HEADLAMP WIPER MOTOR
Service repair no - 84.25.12
Remove
1. Remove relevant wiper blade.
See this section.
2. Remove relevant headlamp assembly.
See
ELECTRICAL, Repair.
3. Release wiper motor multiplug from bracket.
4. Remove spindle seal.
5. Remove nut and flat washer securing motor to
headlamp.
6. Remove wiper motor.
Refit
7. Reverse removal procedure.
8. Tighten motor securing nut to
10 Nm (7 lbf.ft).
WIPER MOTOR AND LINKAGE
Service repair no - 84.15.11
Remove
1. Remove air intake plenum.
See HEATING AND
VENTILATION, Repair.
2. Remove covers from wiper spindles.
3. Remove nuts and flat washers securing wiper
spindle housings.
4. Disconnect screen heater multiplug. Release
multiplug clip from scuttle side panel on driver’s
side of vehicle.
5. Remove 6 bolts securing scuttle side panel.
Remove panel.
WIPERS AND WASHERS
3
REPAIR
6. Disconnect multiplug from wiper motor.
7. Remove 2 bolts securing wiper motor to scuttle.
Remove wiper motor/linkage assembly.
Refit
8. Position wiper motor/linkage assembly. Fit bolts
loosely securing motor to scuttle panel.
9. Position scuttle side panel. Secure with bolts.
10. Connect screen heater multiplug. Secure
multiplug clip to scuttle panel.
11. Secure wiper spindle housings to scuttle with
nuts and flat washers. Tighten to
11 Nm
(8 lbf.ft)
12. Tighten motor securing bolts to
7 Nm (5 lbf.ft)
13. Connect multiplug to wiper motor.
14. Fit covers over wiper spindles.
15. Fit air intake plenum.
See HEATING AND
VENTILATION, Repair.
84
WIPERS AND WASHERS
NEW RANGE ROVER
4
REPAIR
REAR WIPER ARM
Service repair no - 84.35.01 - Wiper Arm
Service repair no - 84.35.02 - Wiper Blade
Remove
1. Remove wiper arm nut cover. Remove nut.
2. Remove wiper arm from motor spindle.
Wiper Blade
3. Release clip. Remove blade from arm
Refit
4. Fit wiper blade to arm.
5. Position arm to motor spindle. Secure with nut.
Tighten to
17 Nm (12 lbf.ft)
6. Fit nut cover.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст