Range Rover. Manual — part 337
NAVIGATION SYSTEM
3
REPAIR
AERIAL - GLOBAL POSITIONING SYSTEM (GPS)
Service repair no - 86.53.05
Remove
1. Disconnect battery earth lead.
2. Open bonnet and cover lower RH ’A’ post to
wing with tape, to prevent clips falling into cavity.
CAUTION: Always protect paintwork when
removing trim finishers.
3. Remove RH windscreen wiper arm.
See
WIPERS AND WASHERS, Repair.
4. With care release RH edge of lower windscreen
finisher from ’A’ post finisher.
5. Carefully release 4 clips securing lower
windscreen finisher to RH side of windscreen.
6. Remove 3 screws from RH plenum cover.
7. Lift RH plenum cover to gain access to GPS
aerial, disconnect lead from waterproof sleeve.
87
NAVIGATION SYSTEM
NEW RANGE ROVER
4
REPAIR
8. Remove plenum cover from vehicle.
9. Remove 2 screws securing GPS aerial to
plenum cover and separate.
Refit
10. Fit GPS aerial to plenum cover and secure with
screws.
11. Connect GPS aerial lead and cover with
waterproof sleeve.
12. Fit plenum cover to vehicle and tighten screws.
13. Raise lower edge of RH ’A’ post finisher, align
lower windscreen finisher and fit clips.
14. Fit wiper arm assembly.
See WIPERS AND
WASHERS, Repair.
15. Remove tape from RH wing.
16. Connect battery earth lead.
DISPLAY UNIT - NAVIGATION SYSTEM
Service repair no - 86.53.20
Remove
1. Remove radio.
See ELECTRICAL, Repair.
2. Remove instrument binnacle.
See
INSTRUMENTS, Repair.
3. Move both front seats to the fully rearward
position.
4. Remove 2 screws securing electric window
switch pack to centre console and position
switch pack aside.
5. Remove 2 screws securing each side panel to
centre console. Release sprag clips from fascia
switch pack by firmly pulling rearwards. Remove
side panels.
NAVIGATION SYSTEM
5
REPAIR
6. Remove 5 screws securing switch pack to centre
console.
7. Move switch pack forward, disconnect 1 lucar
and 11 multiplugs from switch pack and remove
switch pack.
8. Release 4 clips securing satellite navigation
display unit to switch pack and remove display
unit.
Refit
9. Fit satellite navigation display unit to switch pack
and secure clips.
10. Position switch pack to centre console and
connect lucar and multiplugs.
11. Fit switch pack to centre console and secure
with screws.
12. Fit side panels to centre console and secure
clips and screws.
13. Fit electric window switch pack to centre console
and secure with screws.
14. Fit instrument binnacle.
See INSTRUMENTS,
Repair.
15. Fit radio.
See ELECTRICAL, Repair.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст