Range Rover. Manual — part 295
AIR CONDITIONING
1
REPAIR
INTERIOR TEMPERATURE SENSOR
Service repair no - 82.20.93
Remove
1. Remove instrument pack binnacle.
See
INSTRUMENTS, Repair.
2. Move front seats fully rearward.
3. Remove screw securing each side panel to
centre console.
4. Release sprag clip by firmly pulling panel
rearwards. Remove side panels.
5. Remove radio applique.
6. Remove 5 screws securing switch pack.
7. Release switch pack from fascia. Sensor is
located behind grille of switch panel.
8. Disconnect multiplug from interior temperature
sensor.
9. Remove 2 screws securing interior temperature
sensor. Remove sensor.
Refit
10. Reverse removal procedure.
82
AIR CONDITIONING
NEW RANGE ROVER
2
REPAIR
AMBIENT TEMPERATURE SENSOR - UP TO VIN
381430
Service repair no - 82.20.91
Remove
1. Remove plenum air intake panels.
See
HEATING AND VENTILATION, Repair.
2. LHD only: Remove plastic cover, nut and
washers from LH wiper spindle.
3. Disconnect heated screen LH multiplug. Release
plug from clip.
4. Remove 6 bolts securing LH scuttle side panel.
Remove panel.
5. Remove pollen filter.
AIR CONDITIONING
3
REPAIR
6. Turn sensor anti-clockwise. Release from
recirculation flap housing.
7. Remove sensor from multiplug.
Refit
8. Reverse removal procedure.
NOTE:
LHD only: Tighten nut on LH wiper
spindle to
11 Nm (8 lbf.ft)
AMBIENT TEMPERATURE SENSOR - FROM VIN
381431
Service repair no - 82.20.91
Remove
1. Remove front bumper valance.
See CHASSIS
AND BODY, Repair.
2. Disconnect multiplug from sensor.
3. Release sensor locating lug from hole in sensor
mounting bracket, rotate and remove sensor.
Refit
4. Fit sensor to mounting bracket, ensuring that
locating lug is fully engaged.
5. Connect multiplug to sensor.
6. Fit front bumper valance.
See CHASSIS AND
BODY, Repair.
82
AIR CONDITIONING
NEW RANGE ROVER
4
REPAIR
HEATER TEMPERATURE SENSOR
Service repair no - 82.20.94
Remove
1. RHD vehicles. Remove fascia closing panel to
gain access to sensor.
See CHASSIS AND
BODY, Repair.
2. LHD vehicles. Open glove box. Remove 5
screws securing glove box liner to fascia.
3. Release glove box liner. Disconnect lamp
multiplug.
4. Release cable from glove box latch.
5. Lower glove box liner from fascia to gain access
to sensor.
6. All vehicles. Disconnect sensor multiplug.
7. Release clip. Remove sensor from heater feed
pipe.
Refit
8. Reverse removal procedure.
COMPRESSOR DRIVE BELT - DIESEL
Service repair no - 82.10.02
Remove
1. Disconnect battery negative lead.
2. Raise the vehicle.
WARNING: Support on safety stands.
3. Remove cover from tensioner pulley. Slacken
pulley bolt.
4. Remove belt.
Refit
5. Fit belt around crankshaft, compressor and
tensioner pulleys.
6. Adjust belt tension.
See Adjustment.
7. Remove safety stands. Lower vehicle.
8. Reconnect battery negative lead.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст