Range Rover. Manual — part 322
ELECTRICAL
29
REPAIR
FASCIA MOUNTED SWITCHES
Remove
1. Remove instrument pack binnacle.
See
INSTRUMENTS, Repair.
2. Remove screw securing each side panel to
centre console.
3. Disengage sprag clips from fascia switch pack.
Remove side panels.
4. Remove radio applique.
5. Remove 5 screws securing switch pack.
86
ELECTRICAL
NEW RANGE ROVER
30
REPAIR
6. Release switch pack from fascia.
7. Disconnect multiplug from relevant switch.
8. Release clips securing switch to switch pack.
Remove switch.
Refit
9. Reverse removal procedure.
HARNESS - FRONT DOOR
Service repair no - 86.70.65
Remove
1. Remove plastic sheet.
See CHASSIS AND
BODY, Repair.
2. Disconnect window lift motor multiplug.
3. Disconnect puddle lamp multiplug.
4. Disconnect door mirror multiplug.
5. Disconnect 2 door latch motor multiplugs.
6. Release door to body harness sheath at both
ends.
7. Release 2 door harness connectors from body
and disconnect.
8. Release 8 clips securing door harness.
9. Remove harness from door.
Refit
10. Reverse removal procedure.
ELECTRICAL
31
REPAIR
FRONT FOG LAMP
Service repair no - 86.40.96
Remove
1. Raise the vehicle.
WARNING: Support on safety stands.
2. Disconnect multiplug.
3. Disconnect 2 breather tubes.
4. Remove 4 screws securing fog lamp to bumper.
5. Remove fog lamp assembly.
Refit
6. Reverse removal procedure.
FRONT SPEAKER
Service repair no - 86.50.15
Remove
1. Remove front door trim casing.
See CHASSIS
AND BODY, Repair.
2. Remove 4 screws securing speaker.
3. Release speaker. Disconnect multiplug. Remove
speaker.
Refit
4. Reverse removal procedure.
86
ELECTRICAL
NEW RANGE ROVER
32
REPAIR
TWEETER SPEAKER - FRONT DOOR
Service repair no - 86.50.34
Remove
1. Remove cheater panel from door.
2. Rotate tweeter speaker to release from cheater.
3. Disconnect terminals. Remove speaker.
Refit
4. Reverse removal procedure.
IGNITION SWITCH
Service repair no - 86.65.02
Remove
1. Disconnect battery negative lead.
2. Remove steering column nacelle.
See
STEERING, Repair.
3. Remove 3 bolts securing steering tilt lever to
column.
4. Release column tilt lever assembly and plunger.
5. Collect lever return spring.
6. Collect plunger and spring if necessary.
7. Remove 2 screws securing ignition switch.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст