Frelander 2. Manual — part 313
Electronic Engine Controls - TD4 2.2L Diesel - Camshaft Position (CMP)
Sensor
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
2.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
2.
Remove the engine cover.
Refer to:
Engine Cover - TD4 2.2L Diesel
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
3.
4.
5.
Torque: 6 Nm
6.
Remove and discard the hose clips.
7.
8.
Torque: 4 Nm
9.
10.
CAUTION: Incorrect installation of the
camshaft position (CMP) sensor could result in engine
damage.
New CMP sensor only: The CMP sensor tip must rest on
one of the 4 webs on the back of the camshaft pulley,
to achieve the correct alignment of the CMP sensor.
10.
11.
CAUTION: Incorrect installation of the
camshaft position (CMP) sensor could result in engine
damage.
Used CMP sensor only: Insert a 7.5 mm diameter drill
between the valve cover and the CMP sensor as shown,
to achieve the correct alignment of the CMP sensor.
11.
Installation
1.
CAUTION: Make sure that the component is clean, free of
foreign material and lubricant.
To install, reverse the removal procedure.
1.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст