Frelander 2. Manual — part 314
Electronic Engine Controls - TD4 2.2L Diesel - Crankshaft Position (CKP)
Sensor
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the front wheel.
Refer to:
Wheel and Tire
(204-04 W heels and Tires, Removal and
Installation).
2.
3.
4.
CAUTION: Make sure that the wiring harnesses
are correctly located.
Torque: 8 Nm
4.
Installation
To install, reverse the removal procedure.
1.
Electronic Engine Controls - TD4 2.2L Diesel - Engine Coolant Temperature
(ECT) Sensor
Removal and Installation
Removal
Remove the air cleaner assembly.
Refer to:
Air Cleaner
(303-12A Intake Air Distribution and Filtering -
I6 3.2L Petrol, Removal and Installation).
1.
Remove the engine cover.
Refer to:
Engine Cover - TD4 2.2L Diesel
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
2.
Drain the cooling system.
Refer to:
Cooling System Draining, Filling and Bleeding
(303-03B
Engine Cooling - TD4 2.2L Diesel, General Procedures).
3.
4.
WARNING: Do not work on or under a vehicle supported only
by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
4.
5. CAUTIONS:
Be prepared to collect escaping coolant.
A new O-ring seal is to be installed.
5.
6. NOTE: Remove and discard the O-ring seal.
6.
7.
Installation
Connect the engine coolant temperature (ECT) sensor electrical
connector.
1.
2.
CAUTION: A new O-ring seal is to be installed.
Install the engine coolant temperature (ECT) sensor.
2.
Connect the heater outlet pipe.
3.
Install the air cleaner assembly.
Refer to:
Air Cleaner
(303-12A Intake Air Distribution and Filtering -
I6 3.2L Petrol, Removal and Installation).
4.
Install the engine cover.
Refer to:
Engine Cover - TD4 2.2L Diesel
(501-05 Interior Trim and
Ornamentation, Removal and Installation).
5.
Refill and bleed the cooling system.
Refer to:
Cooling System Draining, Filling and Bleeding
(303-03B
Engine Cooling - TD4 2.2L Diesel, General Procedures).
6.
Electronic Engine Controls - TD4 2.2L Diesel - Manifold Absolute Pressure
(MAP) Sensor
Removal and Installation
Removal
1.
Torque: 10 Nm
2.
Installation
To install, reverse the removal procedure.
1.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст