Frelander 2. Manual — part 57
5.
WARNING: Make sure that a new nut is
installed.
Torque: 60 Nm
5.
Torque: 110 Nm
6.
7. NOTE: This step requires the aid of another
technician.
Compress the spring and damper assembly.
Special Tool(s):
204-619
7.
Release the damper from the knuckle assembly.
Special Tool(s):
204-159
8.
9. NOTE: This step requires the aid of another technician.
Release the tension from the spring and damper assembly and
remove the tool.
9.
Remove the spring and damper assembly.
Torque: 30 Nm
10.
Installation
1. CAUTIONS:
Make sure that the brake hose is not twisted and is correctly
located.
Nuts and bolts must be tightened with the weight of the
vehicle on the suspension.
• NOTE: Make sure that the component is clean, free of foreign
material and lubricant.
To install, reverse the removal procedure.
1.
Front Suspension - Spring
Removal and Installation
Removal
• W ARNINGS:
Ensure the spring compressor Safe W orking Load (SWL) meets or exceeds the spring rating quoted in the
Specifcations section.
Always follow the spring compressor manufacturer's instructions.
1.
WARNING: Do not work on or under a vehicle supported only
by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
1.
Remove the road wheel.
Refer to:
Wheel and Tire
(204-04 W heels and Tires, Removal and
Installation).
2.
Remove the spring and damper assembly.
Refer to:
Shock Absorber and Spring Assembly
(204-01 Front
Suspension, Removal and Installation).
3.
Install the spring compressor in a vise.
4.
Install the shock absorber and spring assembly in the spring
compressor.
5.
6.
WARNING: Make sure that a new nut is
installed.
6.
Remove old spring from the spring compressor.
7.
Installation
Install the new spring to the compressor and compress sufficiently.
1.
2. WARNINGS:
Make sure that a new nut is installed.
It is imperative that the timing marks are
aligned as shown in illustration.
Torque: 80 Nm
2.
Release the tension from the spring and damper assembly and
remove from the special tool.
3.
Remove the spring compressor from a vise.
4.
Install the spring and damper assembly.
Refer to:
Shock Absorber and Spring Assembly
(204-01 Front
Suspension, Removal and Installation).
5.
Install the road wheel.
Refer to:
Wheel and Tire
(204-04 W heels and Tires, Removal and
Installation).
6.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст