Frelander 2. Manual — part 101
Refer to:
Rear Halfshaft LH
(205-05 Rear Drive Halfshafts, Removal
and Installation).
Rear Drive Halfshafts - Outer Constant Velocity (CV) Joint Boot
Removal and Installation
Special Tool(s)
303-D121
Puller, General Purpose
Removal
• NOTE: The outer Constant Velocity joint must not be removed from the shaft. The inner joint and gaiter have to be
removed to facilitate gaiter replacement of the outer C. V. gaiter. The inner and outer gaiters are supplied together as a
kit.
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the halfshaft.
Refer to:
Rear Halfshaft LH
(205-05 Rear Drive Halfshafts, Removal
and Installation).
2.
3. NOTE: Discard the retaining clips.
3.
4. NOTE: Discard the retaining clips.
4.
5.
6. NOTE: Discard the retaining clip.
6.
Special Tool(s):
303-D121
7.
Installation
1.
CAUTION: Extreme cleanliness must be exercised when
handling these components.
Clean and inspect the components for deterioration.
1.
Install the inner and outer CV boots onto the halfshaft.
2.
3. NOTE: Install a new retaining clip.
Install the inner CV joint inner onto the halfshaft.
3.
4.
CAUTION: Make sure that these components are installed to
4.
the noted removal position.
Install the inner CV joint outer onto the halfshaft.
Pack the inner CV joint with the grease supplied.
5.
Pack the outer CV joint with the grease supplied.
6.
7. NOTE: Install new retaining clips.
Secure the inner CV joint boot to the inner CV joint.
7.
8. NOTE: Install new retaining clips.
Secure the outer CV joint boot to the outer CV joint.
8.
Install the halfshaft.
Refer to:
Rear Halfshaft LH
(205-05 Rear Drive Halfshafts, Removal
and Installation).
9.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст