Frelander 2. Manual — part 141
Torque: 10 Nm
7.
Installation
To install, reverse the removal procedure.
1.
Check and top-up power steering fluid level.
Refer to:
Power Steering System Bleeding
(211-00 Steering System -
General Information, General Procedures).
2.
Power Steering - Power Steering Fluid Reservoir
Removal and Installation
Removal
Remove the power steering fluid reservoir cap.
1.
Using a suitable syringe, remove the power steering fluid from the
power steering fluid reservoir.
2.
3. CAUTIONS:
Be prepared to collect escaping fluids.
Make sure that all openings are sealed. Use new
blanking caps.
Remove the power steering fluid reservoir.
3.
Installation
To install, reverse the removal procedure.
1.
Fill and bleed the power steering system.
Refer to:
Power Steering System Bleeding
(211-00 Steering System -
General Information, General Procedures).
2.
Steering Linkage -
Torque Specifications
Description
Nm
lb-ft
Tie-rod end nut
70
52
Tie-rod locking nut
55
41
Steering Linkage - Steering Linkage
Description and Operation
COMPONENT LOCATION
Item
Part Number
Description
1
-
Ball joint
2
-
Locknut
3
-
Tie rod end
4
-
Locknut
5
-
Tie rod
6
-
Steering gear boot
7
-
Steering gear
OVERVIEW
The outer ends of the tie rods are threaded to allow the fitment of the tie rod ends. The tie rod ends are screwed onto the
tie rods and locked with locknuts to prevent inadvertent movement. The thread on the tie rod allows the position of the tie
rod end to be adjusted in order to set the correct toe angle for each front wheel. The tie rod has a ball fitting which is
screwed into the end of the steering gear. A boot is fitted to the steering gear to protect the ball fitting from dirt and
moisture.
The tie rod end comprises a forged housing with a threaded bore for attachment to the tie rod. The tie rod end
incorporates a non-serviceable tapered ball joint which locates in a tapered hole in the front wheel knuckle and is secured
with a self-locking nut. The ball joint has an internal hexagonal drive which enables the joint to be held stationary when
the self-locking nut is tightened.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст