Frelander 2. Manual — part 142
Steering Linkage - Steering Linkage
Diagnosis and Testing
For additional information.
REFER to:
Steering System
(211-00 Steering System - General Information, Diagnosis and Testing).
Steering Linkage - Tie Rod End
Removal and Installation
Special Tool(s)
205-754
Splitter, Ball Joints
Removal
1.
WARNING: Do not work on or under a vehicle supported only
by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
1.
Remove the front wheel.
Refer to:
Wheel and Tire
(204-04 W heels and Tires, Removal and
Installation).
2.
Loosen the tie-rod end lock nut.
3.
4.
CAUTION: Make sure that the ball joint ball
does not rotate.
Release the tie-rod end ball joint from the wheel
knuckle.
Special Tool(s):
205-754
4.
5.
CAUTION: Note the number of turns when
removing the tie rod end to aid installation.
Remove the tie-rod end.
5.
Installation
1.
CAUTION: Make sure that the tie rod end is installed with
1.
the same number of turns as when removed.
Install the tie-rod end.
2.
WARNING: Make sure that a new tie-rod end nut is
installed.
• CAUTIONS:
Make sure that the mating faces are clean and free of foreign
material.
Make sure that the ball joint ball does not rotate.
Connect the tie-rod end ball joint.
Torque: 70 Nm
2.
3.
CAUTION: Make sure that the mating faces are clean and
free of foreign material.
Tighten the tie-rod locking nut.
Torque: 55 Nm
3.
Install the front wheel.
Refer to:
Wheel and Tire
(204-04 W heels and Tires, Removal and
Installation).
4.
Using only four wheel alignment equipment approved by Land Rover,
check and adjust the wheel alignment.
5.
Steering Linkage - Steering Gear Boot
Removal and Installation
Removal
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the tie rod end.
Refer to:
Tie Rod End
(211-03 Steering Linkage, Removal and
Installation).
2.
3. NOTE: Note the fitted position.
3.
4.
Installation
1. CAUTIONS:
Make sure that the mating faces are clean and free of foreign
material.
Make sure that the boot is correctly located.
To install, reverse the removal procedure.
1.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст