Frelander 2. Manual — part 63
Rear Suspension - Rear Stabilizer Bar Link
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the wheel and tire.
Refer to:
Wheel and Tire
(204-04 W heels and Tires, Removal and
Installation).
2.
3. CAUTIONS:
Make sure that the ball joint ball does not rotate.
Discard the nuts.
Torque: 60 Nm
3.
Installation
To install, reverse the removal procedure.
1.
Rear Suspension - Wheel Knuckle
Removal and Installation
Special Tool(s)
204-159
Lever, Wheel Knuckle
204-528/2
Remover/Installer, Bushing
204-620-01
Installer, Wheel Knuckle Bushing
204-620-02
Remover/Installer, Wheel Knuckle Bushing
204-620-03
Remover, W heel Knuckle Bushing
205-725
Remover/Installer, Wheel Hub
205-726
Remover/Installer, Wheel Hub Bearing
205-728
Remover/Installer, Wheel Hub
205-802/5
Remover, W heel Hub/Bearing
205-857
Remover, Halfshaft
LR-121
Hydraulic Cylinder 10t
Removal
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the wheel and tire.
Refer to:
Wheel and Tire
(204-04 W heels and Tires, Removal and
Installation).
2.
3.
CAUTION: Do not use a hammer to detach the
halfshaft from the hub assembly, failure to follow this
instruction may result in damage to the halfshaft.
Remove and discard the rear halfshaft nut.
3.
4.
CAUTION: Discard the nut.
• NOTE: RH illustration shown, LH is similar.
4.
Release the wheel speed sensor from the wheel
knuckle.
5.
6.
CAUTION: Make sure that no load is placed on
the brake hose.
Tie the brake caliper and brake caliper anchor
plate assembly aside.
6.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст