Frelander 2. Manual — part 62
Rear Suspension - Trailing Arm
Removal and Installation
Removal
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the wheel and tire.
Refer to:
Wheel and Tire
(204-04 W heels and Tires, Removal and
Installation).
2.
3.
4.
Installation
Install the trailing link.
1.
Fit nuts, bolts and washers securing the trailing link to the body and
hub, but do not tighten at this stage.
2.
3.
CAUTION: Nuts and bolts must be tightened with the weight
of the vehicle on the suspension.
Support weight of vehicle on a jack at the rear hub.
3.
Tighten the nuts and bolts.
Torque: 270 Nm
4.
Install the wheel and tire.
Refer to:
Wheel and Tire
(204-04 W heels and Tires, Removal and
Installation).
5.
Check and if necessary, adjust the rear wheel alignment
6.
Rear Suspension - Rear Stabilizer Bar
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
2. CAUTIONS:
Make sure that the ball joint ball does not rotate.
Discard the nuts.
Disconnect both rear stabilizer bar links from the
stabilizer bar.
Torque: 60 Nm
2.
Remove the stabilizer bar bushings.
Refer to:
Rear Stabilizer Bar Bushing
(204-02 Rear Suspension,
Removal and Installation).
3.
4.
CAUTION: Note the fitted position of the component prior to
removal.
Remove the stabilizer bar.
4.
Installation
To install, reverse the removal procedure.
1.
Rear Suspension - Rear Stabilizer Bar Bushing
Removal and Installation
Removal
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
2.
CAUTION: Discard the bolts.
• NOTE: Muffler has been removed for clarity.
2.
3.
Installation
1.
CAUTION: Make sure that the component is clean, free of
foreign material and lubricant.
Install the stabilizer bar bushings.
1.
2.
CAUTION: Make sure that the component is clean, free of
foreign material and lubricant.
Install the stabilizer bar clamps.
2.
3.
CAUTION: Make sure that new bolts are installed.
Install the bolts, but do not tighten fully at this stage.
3.
4.
CAUTION: Nuts and bolts must be tightened with the weight
of the vehicle on the suspension.
Tighten the stabilizer bar clamp bolts.
4.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст