Frelander 2. Manual — part 309
Electronic Engine Controls - I6 3.2L Petrol - Fuel Rail Pressure (FRP) Sensor
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Remove the cover and disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
Remove the fuel rail.
Refer to:
Fuel Rail
(303-04A Fuel Charging and Controls - I6 3.2L
Petrol, Removal and Installation).
2.
Torque: 6 Nm
3.
Installation
To install, reverse the removal procedure.
1.
Electronic Engine Controls - I6 3.2L Petrol - Front Knock Sensor (KS)
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
1.
WARNING: Do not work on or under a vehicle supported only
by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
1.
Remove the oil cooler assembly.
Refer to:
Oil Cooler
(303-01A Engine - I6 3.2L Petrol, Removal and
Installation).
2.
3. CAUTIONS:
Make sure that the mating faces are clean and
free of corrosion and foreign material.
Mark the components to aid installation.
Remove the knock sensor (KS).
Torque: 20 Nm
3.
Installation
To install, reverse the removal procedure.
1.
Electronic Engine Controls - I6 3.2L Petrol - Rear Knock Sensor (KS)
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
1.
WARNING: Do not work on or under a vehicle supported only
by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
1.
Remove the intake manifold.
Refer to:
Intake Manifold
(303-01A Engine - I6 3.2L Petrol, Removal
and Installation).
2.
3. CAUTIONS:
Make sure that the mating faces are clean and
free of corrosion and foreign material.
Mark the components to aid installation.
Remove the knock sensor (KS).
Torque: 20 Nm
3.
Installation
To install, reverse the removal procedure.
1.
Electronic Engine Controls - TD4 2.2L Diesel -
General Specification
Item
Specification
Engine management system:
Make
BOSCH
Type
EDC 15 C2
Camshaft position sensor:
Make
Electrifil
Type
Hall effect
Crankshaft position sensor:
Make
Electrifil
Type
Hall effect
Torque Specifications
Description
Nm
lb-ft
Camshaft position (CMP) sensor retaining bolt
6
5
Crankshaft position (CKP) sensor retaining bolt
10
7
Engine oil pressure (EOP) sensor
35
26
Intake air temperature sensor (IAT)
10
7
Intake Manifold Runner Control (IMRC) Actuator
10
7
Manifold absolute pressure (MAP) sensor
10
7
Mass air flow (MAF) sensor retaining screws
2
1
Oil temperature/level sensor
27
20
Turbocharger Boost Pressure Sensor
8
7
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст