Frelander 2. Manual — part 308
Electronic Engine Controls - I6 3.2L Petrol - Manifold Absolute Pressure
(MAP) Sensor
Removal and Installation
Removal
1.
WARNING: Do not work on or under a vehicle supported only
by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
1.
Remove the engine undershield.
Refer to:
Engine Undershield
(501-02 Front End Body Panels,
Removal and Installation).
2.
3.
4.
5.
6.
Installation
To install, reverse the removal procedure.
1.
2. NOTE: For NAS vehicles only.
If required, carry out a short drive cycle.
Refer to: Powertrain Control Module (PCM) Short Drive Cycle
Self-Test (303-14A, General Procedures).
2.
Electronic Engine Controls - I6 3.2L Petrol - Engine Control Module (ECM)
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Remove the cover and disconnect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
1.
Remove the plenum chamber panel.
Refer to:
Plenum Chamber
(412-01 Climate Control, Removal and
Installation).
2.
3.
Petrol ECM shown, diesel similar.
4.
Torque: 6 Nm
5.
Installation
All vehicles
To install, reverse the removal procedure.
1.
Vehicles with diesel particulate filter (DPF)
Renew the engine oil and filter.
Refer to:
Engine Oil Draining and Filling
(303-01B Engine - TD4 2.2L
Diesel, General Procedures).
2.
All vehicles
If a new component has been installed, configure using Land Rover
approved diagnostic equipment.
3.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст