Frelander 2. Manual — part 120
Remove the speed control deactivation switch.
7.
Installation
To install, reverse the removal procedure.
1.
Hydraulic Brake Actuation - Brake Pedal Control Switch
Removal and Installation
Removal
Remove the closing panel.
1.
Remove the stoplamp switch.
2.
Installation
To install, reverse the removal procedure.
1.
Hydraulic Brake Actuation - Brake Master Cylinder
Removal and Installation
Removal
• CAUTIONS:
Extreme cleanliness must be exercised when handling these components.
If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.
• NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the brake fluid reservoir.
Refer to:
Brake Fluid Reservoir
(206-06 Hydraulic Brake Actuation,
Removal and Installation).
2.
Right-hand drive vehicles
3. NOTE: Torque applies to bolt only.
Torque: 10 Nm
3.
All vehicles
4. CAUTIONS:
Be prepared to collect escaping fluids.
Make sure that all openings are sealed.
Torque: 15 Nm
4.
5. CAUTIONS:
Be prepared to collect escaping fluids.
The seal is to be reused unless damaged.
Torque: 26 Nm
5.
Installation
To install, reverse the removal procedure.
1.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст