Frelander 2. Manual — part 378
3.
Torque: 25 Nm
4.
Torque: 65 Nm
5.
Special Tool(s):
308-617
6.
7. CAUTIONS:
Make sure that the area around the component is
clean and free of foreign material.
Take extra care not to damage the mating faces.
Special Tool(s):
308-615
,
100-012
7.
Installation
Special Tool(s):
205-872
1.
To install, reverse the removal procedure.
2.
Check and top-up the transfer case fluid level.
Refer to:
Transfer Case Fluid Level Check
(308-07B Transfer Case,
General Procedures).
3.
Transfer Case - Transfer Case Vent
Removal and Installation
Removal
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
2.
CAUTION: Make sure that the area around the
component is clean and free of foreign material.
2.
Installation
To install, reverse the removal procedure.
1.
Exhaust System - I6 3.2L Petrol -
Lubricants, Fluids, Sealers and Adhesives
Item
Specification
Heated oxygen sensor (H02S) removal*
WD40 or Suitable alternative
Heated oxygen sensor (H02S) threads
Apply suitable high temperature anti-seize compound to threads of sensor
* Apply to area around sensor threads prior to attempting to remove sensor
General Specification
Item
Specification
Catalytic converters
- location
Fitted in the front section of the exhaust system
Exhaust manifolds
Manifold assemblies (2) with three fabricated branches merging into an integral catalytic converter
are fitted to the cylinder head.
Exhaust system
stainless steel exhaust system supplied as two separate assemblies. Front section incorporating two
catalytic converters and a rear section incorporating centre and rear silencers
Torque Specifications
Description
Nm
lb-ft
Catalyst monitor sensor
45
33
Catalytic converter to exhaust manifold bolts*
30
22
Catalytic converter to centre muffler nuts and retaining clamp
24
18
Exhaust manifold bolts
A
A
Exhaust manifold heatshield bolts
10
7
Exhaust support brackets to front subframe / floor bolts
24
18
Exhaust support bracket to centre bearing carrier bolts
24
18
Exhaust tail pipe trim screws
3
2
Front muffler service sleeve clamp nuts
40
28
Heated oxygen sensor (H02S)+
45
33
* It is not appropriate to either fit or remove these fixings using air tools due to a risk of cold welding/snapping.
+ Apply anti-seize lubricant to threads of sensor - See Lubricants
A = refer to procedure for correct torque sequence
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст