Frelander 2. Manual — part 215
Engine - TD4 2.2L Diesel - Exhaust Manifold
Removal and Installation
Removal
WARNING: Observe due care when working near a hot exhaust system.
1.
WARNING: Make sure to support the vehicle with axle
stands.
Raise and support the vehicle.
1.
Remove the exhaust gas recirculation (EGR) cooler.
Refer to:
Exhaust Gas Recirculation (EGR) Cooler
(303-08B Engine
Emission Control - TD4 2.2L Diesel, Removal and Installation).
2.
Remove the catalytic converter.
Refer to:
Catalytic Converter - Vehicles Without: Diesel Particulate
Filter (DPF)
(309-00B Exhaust System - TD4 2.2L Diesel, Removal
and Installation).
3.
4. NOTE: Make sure that all openings are sealed.
4.
5.
6. CAUTIONS:
Make sure that the area around the component is
clean and free of foreign material.
Make sure that all openings are sealed. Use new
blanking caps.
6.
7.
8.
CAUTION: Make sure that all openings are
sealed. Use new blanking caps.
Release the turbocharger.
8.
Remove the EGR cooler to exhaust manifold elbow.
9.
10.
CAUTION: Make sure that all openings are
sealed. Use new blanking caps.
• NOTE: Discard the gasket.
10.
Installation
1.
CAUTION: Make sure that the area around the
component is clean and free of foreign material.
Install a new gasket.
Install the exhaust manifold.
Evenly and progressively, tighten the bolts in
the sequence shown.
Torque: 25 Nm
1.
Install the EGR cooler to exhaust manifold elbow.
Torque: 10 Nm
2.
3. CAUTIONS:
Make sure that new bolts are installed.
Extreme cleanliness must be exercised when handling this
component.
Carbon deposits must be carefully removed from both faces of
the turbocharger and exhaust manifold prior to assembly.
Install the turbocharger.
3.
Torque: 24 Nm
Install the turbocharger support bracket, but do not fully
tighten at this stage.
Tighten the support bracket to turbocharger bolt.
Torque: 24 Nm
Tighten the support bracket to cylinder block bolts.
Torque: 24 Nm
4.
5. CAUTIONS:
Make sure that the area around the component is clean and
free of foreign material.
Make sure that new sealing washers are installed.
Connect the turbocharger oil feed line.
Torque: 24 Nm
5.
Install the turbocharger outlet pipe.
Torque: 25 Nm
6.
Install the catalytic converter.
Refer to:
Catalytic Converter - Vehicles Without: Diesel Particulate
Filter (DPF)
(309-00B Exhaust System - TD4 2.2L Diesel, Removal
and Installation).
7.
Install the EGR cooler.
Refer to:
Exhaust Gas Recirculation (EGR) Cooler
(303-08B Engine
Emission Control - TD4 2.2L Diesel, Removal and Installation).
8.
Check and top-up the engine oil.
9.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст