Frelander 2. Manual — part 595
1
1
1
2
3
4
1
Carry out visual and manual inspection of the rear sliders and
the connecting bar for damage (pieces broken) and correct
location.
Are the rear sliders or connecting bar damaged / jammed?
Yes
Replace the damaged rear slider(s) or connecting bar as
required.
No
GO to C17
.
C17: GLASS MOUNTED GUIDE BRACKETS
Visually inspect the glass mounted guide brackets on the
glass panels for damage.
Are the glass mounted guide brackets damaged?
Yes
Install a new opening panel glass.
REFER to:
Roof Opening Panel Glass
(501-17 Roof Opening
Panel, Removal and Installation).
No
GO to C18
.
C18: GLASS PANEL - REASSEMBLY
Install the rails using the 20 machine screws that secure the
glass panel guide(s) if previously removed.
Re-assemble the glass panel onto the roof opening panel.
REFER to:
Roof Opening Panel Glass
(501-17 Roof Opening
Panel, Removal and Installation).
Perform the manual roof opening panel initialization
procedure.
REFER to:
Motor Synchronization
(501-17 Roof Opening
Panel, General Procedures).
Check for correct roof opening panel operation.
Does the roof opening panel operate correctly?
Yes
No further action required.
No
Contact dealer technical support.
PINPOINT TEST D : ROOF OPENING PANEL - BOUNCE BACK
TEST CONDITIONS
DETAILS/RESULTS
/ACTIONS
D1: INITIALIZATION
• NOTE: These tests are to be carried out to determine the cause of the unnecessary roof opening panel bounce back.
Perform the
manual roof
opening panel
initialization
procedure.
2
3
1
2
3
REFER to:
Motor
Synchronization
(501-17 Roof
Opening Panel,
General
Procedures).
Operate the
roof opening
panel through
all possible
positions (slide
open / slide
close / tilt open
/ tilt close)
using the roof
mounted
switch.
Operate the
roof opening
panel one
touch function
five times in
succession
using the roof
mounted
switch.
Does the roof
opening panel
operate correctly
five times in
succession?
Yes
No further
action required.
No
GO to D2
.
D2: INCORRECT SEAL LOCATION CAUSING BOUNCE-BACK
Visually inspect
the location of
the roof
opening panel
seals.
Drip Lip
Front Acoustic
Seal
Vehicles
built up to
VIN 154971.
Vehicles
built from
VIN 154972.
4
5
Side Acoustic
Seal
Aperture Seal
Are any of the seals
causing the bounce
back?
Yes
GO to D3
.
No
GO to D8
.
D3: SIDE ACOUSTIC SEAL - LOCATION
1
1
Visually inspect
the roof
opening panel
side acoustic
seals.
Is the bounce back
caused by either of
the roof opening
panel side acoustic
seals?
Yes
Replace the
side acoustic
seals. Clean all
relevant
surfaces then
correctly
position and
bond the new
side acoustic
seals to the
roof opening
panel.
GO to
D4
.
No
GO to D4
.
D4: FRONT ACOUSTIC SEAL - LOCATION
Visually inspect
the roof
opening panel
front acoustic
seal.
Vehicles
built up to
VIN 154971.
Vehicles
built from
VIN 154972.
Is the bounce back
caused by the roof
opening panel front
acoustic seal?
Yes
Replace the
front acoustic
seal. Clean all
relevant
surfaces then
correctly
position and
bond the front
acoustic seal to
the roof
opening panel.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст