Frelander 2. Manual — part 432
Install the glove compartment.
Refer to:
Glove Compartment
(501-12 Instrument Panel and
Console, Removal and Installation).
10.
Install the passenger side instrument panel end trim panel.
11.
Secure the wiring harness support bracket.
12.
Install the climate control assembly.
13.
Install the audio unit.
14.
Install the center speaker.
15.
Install the video display.
Refer to:
Video Display
(415-01 Information and Entertainment
System, Removal and Installation).
16.
Install both instrument panel speakers.
17.
Install both upper trim panels.
18.
Connect the in-vehicle temperature sensor electrical connector.
19.
Connect the keyless start module electrical connector.
20.
Install the instrument cluster.
Refer to:
Instrument Cluster
(413-01 Instrument Cluster, Removal
and Installation).
21.
Install the clockspring.
Refer to:
Clockspring
(501-20B Supplemental Restraint System,
Removal and Installation).
22.
Install the instrument panel.
Refer to:
Instrument Panel - TD4 2.2L Diesel
(501-12 Instrument
Panel and Console, Removal and Installation).
Refer to:
Instrument Panel - I6 3.2L Petrol
(501-12 Instrument Panel
and Console, Removal and Installation).
23.
Connect the battery ground cable.
Refer to:
Specifications
(414-00 Battery and Charging System -
General Information, Specifications).
24.
Return the steering column to its original position.
25.
Climate Control - Air Conditioning (A/C) Pressure Transducer
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Remove the plenum chamber.
Refer to:
Plenum Chamber
(412-01 Climate Control, Removal and
Installation).
1.
2. CAUTIONS:
Extreme cleanliness must be exercised when
handling these components.
Make sure that all openings are sealed. Use new
blanking caps.
• NOTE: Use an additional wrench to prevent the
component from rotating.
Torque: 8 Nm
2.
Installation
To install, reverse the removal procedure.
1.
Climate Control - Temperature Blend Door Actuator LHRHD AWD
Removal and Installation
Removal
Remove the glove compartment.
Refer to:
Glove Compartment
(501-12 Instrument Panel and
Console, Removal and Installation).
1.
2.
3.
Installation
To install, reverse the removal procedure.
1.
If a new component has been installed, configure using Land Rover
approved diagnostic equipment.
2.
Climate Control - Temperature Blend Door Actuator LHLHD AWD
Removal and Installation
Removal
• NOTE: Removal steps in this procedure may contain installation details.
Make the SRS system safe.
Refer to:
Standard W orkshop Practices
(100-00 General Information,
Description and Operation).
1.
Remove the steering column.
Refer to:
Steering Column
(211-04 Steering Column, Removal and
Installation).
2.
Remove the driver lower air bag module support
bracket.
Torque: 7 Nm
3.
4.
Installation
To install, reverse the removal procedure.
1.
If a new component has been installed, configure using Land Rover
approved diagnostic equipment.
2.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст